Rough runnin classic

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

Mk Mudpie

New Member
Posts
84
Location
Milton keynes
Hillo peeps , Strange rover been runnin fine with all the help i was given last time round , so here we go again , tick over is really poor but runnin on the road is good , have'nt done any work in the engine bay cept 4 magnacor leads , dizzie cap an rotor arm , so tick over , she threatens to cut out if u stop say at traffic lights and if left long enough tends to get back into a normal rythm , on a run she is an absolute dream , no missin an really smooth , all help muchly appreciated , many thanx an happy summer Tom . oh yeah she a 93 v8 classic
 
Have taken out , cleaned an replaced the stepper motor , still threatens to die especially when u 1st start her up , appears 2 hunt 4 a while then cathes up , when u come 2 a full stop the revs drop 2 almost nothin then picks up , have replaced the air filter
 
throttle position sensor!!!!!!!!!!!!!!!!!!!!!

Oh and si , kev and stu are scared of you showin your arse a 7th time so are hiding lol :D
 
Morning!

I would go for stepper first but I would also suggest take off the plenum and ram housing and give it all a good clean, re-set/check base idle, clean and set the throttle disc, check the vac lines attached to the plenum (you might have a small vacuum leak) and give the breathers a clean. Might also be worth putting a strobe on it and checking ignition timing. I know that might sound like a lot to do but it is only a couple of hours work and normally well worth it.
 
Ok , where do i start , have taken out , checked gappin replaced plugs , checked dizzy cap an arm , cleaned replaced accordingly , taken all air system apart , cleaned repaced couple pipes from the plenum due 2 fallin apart as soon i i went near them ,how ever there is a pipe at the front left side of the plenum as u look at it that has been blanked off , any body no where its supposed 2 go ? bin 4 a drive at the speed limit lol an as yet no better . have'nt checked the timin yet , she seems 2 run so well its jus when u stop , when u start her from cold say in the mornin she appears 2 b missin , tried takin off leads when runnin but cant track down which cylinder misses , she runs the same which ever lead u remove
 
Mk Mudpie said:
Ok , where do i start , have taken out , checked gappin replaced plugs , checked dizzy cap an arm , cleaned replaced accordingly , taken all air system apart , cleaned repaced couple pipes from the plenum due 2 fallin apart as soon i i went near them ,how ever there is a pipe at the front left side of the plenum as u look at it that has been blanked off , any body no where its supposed 2 go ? bin 4 a drive at the speed limit lol an as yet no better . have'nt checked the timin yet , she seems 2 run so well its jus when u stop , when u start her from cold say in the mornin she appears 2 b missin , tried takin off leads when runnin but cant track down which cylinder misses , she runs the same which ever lead u remove
Click to expand...

Have you used genuine cap and arm or are they pattern parts from Halfords?

The blanked off pipe on the plenum - if it is the one I think it is this is normal, nothing to worry about.

Are all your ignition leads in the right place and properly clipped. There is a diagram for lead routing and it is helpful if each lead is in the right place and clipped.
 
even lucas cap and arms are ****e it needs to landrover-lucas as I found out after alot of time fooking about!

If the stepper checks out invest in a new throttle position sensor they are only £20, easy to fit and yours has the exact same symptoms as mine did untill I changed the tps!
 
Strange rover made it home quicker than she got there . Got a small overheatin problem now but then she aint bin that fast 4 a long time lol , tick over seems 2 b holdin her own , pick up is much better , im not terrified 2 stop at junctions now , will get the bits u suggested an go from there , Thanx 4 ur help classic kev
 
Mk Mudpie said:
Strange rover made it home quicker than she got there . Got a small overheatin problem now but then she aint bin that fast 4 a long time lol , tick over seems 2 b holdin her own , pick up is much better , im not terrified 2 stop at junctions now , will get the bits u suggested an go from there , Thanx 4 ur help classic kev
Click to expand...

Good! Definately made some progress then. If it's getting hot I suspect your rad is clogged. Best bet will unfortunately be to remove it, clear the core but only use a hose - a pressure washer will destroy it. Also, pop the grille off and hose out the disused air con rad. Better still as your A/C has no compressor, remove it completely.

Back to the main rad, once youve cleaned it outside, reverse flush it, that should sort it. No way should it try to cook itself with a properly working viscous fan - those things really move air.

Catch yers later.
 
You must log in or register to reply here.

Similar threads

Saint.V8
Classic 44 Year old, seized, corroded V8 rebuild thread.....
12 13 14
Replies
268
Views
40K
Henry_b
Henry_b
Saint.V8
My much loved 1999 BMW 735i in Glacier Green (silver-ish)
Replies
8
Views
2K
Saint.V8
Saint.V8
M
93 classic v8 , running not running running not running
Replies
16
Views
2K
jamesmartin
jamesmartin
ronsealdeath
1990 Range Rover Classic 3.9 v8i Auto
Replies
4
Views
2K
Shabs
S
M
rangy wont start
2
Replies
26
Views
3K
1992lse
1992lse
Back
Top