Hi people, Just a quick question on my gearbox. Whilst it’s semi dismantled I’m freeing up all the levers of years of crud and rust. I’ve taken the gear shift lever housing apart and noticed I don’t have the grub screw that goes through the housing to engage with the slot on the ball. I’ve not driven the vehicle since I bought it (it’s now in mid full rebuild) so don’t know if it’s something I need to replace? Also is it worth a little cv grease in the hall housing? Thanks.
Gear stick ball housing question
- Thread starter Gertie36
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Colthebrummie
Well-Known Member
- Posts
- 9,870
- Location
- Thatcham
The grub screw helps to eliminate some of the play but it shouldn't be tightened too much. A bit of grease is ok if the housing is dry.
Col
Col
Riggwelter
Active Member
- Posts
- 186
- Location
- Sweden
Here is a report on a gear stick overhaul. The company Online Gearbox Parts sell the Slickshift, should it be of interest.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
yes to both
