Only happen on wet muddy roads.So not very often in Australia Two way clunk, ie out then back in. Front right hand side. Wheel is firm and steering fine. Also just renewed short right angle rubber inlet to manifold from intercooler on Puma 2.2. If any one whats to know the easiest way, I finally found it through trial and error.
200 series Defender clunks in the wet
- Thread starter Stokesie
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
Hello and welcome to LZ
doriz
Well-Known Member
- Posts
- 17,312
Welcome, we like to see folks land rovers so add a picture
RangeRoller dt
Well-Sprung Member
- Posts
- 14,410
- Location
- Trapped inside my head @ LZ asylum
Welcome to LandyZone
Western Slope Rover
Well-Known Member
- Posts
- 4,073
- Location
- On a mesa
Another Land Rover enigma.
Turboman
Mab An Gov
- Posts
- 60,151
- Location
- Lathrowda, Kernow
Welcome to LZ.
Link to Defender section below
https://www.landyzone.co.uk/forum/defender-90-110-130.7/
- Posts
- 45,046
- Location
- East Dorset
Hiya, Cobber! Welcome to the asylum!
Shock absorber bolt gone?
Shock absorber bolt gone?
Its been getting worse so we had a good look the other day and saw the front universal flexing were it goes into the diff. so pulled out the radial arms and replaced bushes with Nolathane ones and fixed her better than a bought one. Hard getting the old ones out found it best to just lie the whole arm in a sleepy camp fire and then deal with the remaining collar with a hack saw.
Similar threads
