Search results

I asked my friend to send me some pictures when she told me her Farm looked like a Land Rover Car park!! Nice to see them all lined up :D

Hi Everyone, Had a bad Sunday the clutch pedal goes to the ground whilst waiting in traffic, so pops the bonnet see some fluid around the pipework. Get it back home from breakdown, and so gets a master cylinder, slave cylinder and clutch bleeding kit. I am having really a bad time trying to...

Hi Everyone Ok here is the story so far, first I thought my ECU had gone as I had nothing when I tried to start it and was going to send it to Irish Rover to have it synced with my BECM just in case but found in the end it was a blown fuse thankfully :doh: so replaced that and got it started...

Hello Everyone, Can anyone help me I am trying to locate a supplier for the brake disc guard for my discovery 1. I have searched here and googled it but cannot find a supplier yet. Any advice woudl be appreciated :D Matt

You should see how much second hand Range Rovers go for in the Philippines. If you check out the car adverts for Range Rover in the Philippines, there is a N Reg 4.6 1995, admittedly only 48000 miles but its selling for £13690 :eek: A RRC 1995 with 97,100 miles at a price of £10392.00 another...

Hi everyone, can anyone shed some light on my problem please. I have just changed the head gasket put evrything back but on start up it is running bad. High revs is fine but it wont tick over on its own yet and there is a popping sound when you try and get it on a low rev. If you let go of the...

Got you thinking didn't it ;) Just finished changing the head gasket putting everything all back, thankfully nothing left over :rolleyes: Ran out of light now as I wanted to start it whilst there was some daylight so I can check if there are any leaks etc, So.... what was you feeling the...

Hi Could anyone offer their advice for fitting the valve stem seals. I can't seem to get them to fully seat properly I don't want to damage them but they are really tight to get fully pressed down onto the rim. Many thanks

Hello everyone, Could anyone offer some advice for the wiring for the spade connector to the starter motor, the one for the solenoid. I have noticed that the plastic wire sheath has split in a couple of areas and I am sure this is causing some problems when trying to start, I have found...

Head Gasket nearly done, admittedly not as quick as Gav's :D I had a flaming rounded bolt and had to dremel the sides before I could get a decent socket on it to get it undone. I thought I would clean a few things up before I can get them to the machine shop for skimming...

Hi everyone, From my previous thread, can someone advise if I have to take off the air con condensor and power steering pump to take off the valley gasket or can I leave them on? I am hoping to get the heads off on Saturday but I don't particularly want to mess too much with the air con if...

Hi everyone, From my previous thread, Gav has advised that I may have to look at and change my stem seals, when I was looking on how to change them, its basically not a great deal more to then go on and do the Head gasket too. What do you reckon? to be safe than sorry and to do the head...

Hi Everyone, I could do with some advice please. My Rangy seems to be blowing some excessive smoke when I accelerate but only then. Normal tickover fine, driving normally seems fine, but pulling away at junctions roundabouts etc then it does seem to throw out quite a bit of smoke. Greyish...

Hello everyone, Can you offer some advice on my radiator please. I noticed that my radiator has some cool spots and mainly at the bottom of the rad it is quite cool, also the bottom pipe from the rad to the thermostat is quite cool. The rest of the pipes are fairly warm. I was thinking of...

Hi Everyone, Can anyone recommend a good alternator for my Range Rover 4.6 Petrol/Lpg 1997. Are any interchangeable between different Land Rover models? Or has anyone got one to sell? Many thanks :) Matt

Hi everyone For some reason now I am only getting cold air from the vents until I start driving the car. I recently replaced the crank seal (see thread) I thought I may of had an air lock or faulty water pump which was replaced and have bled the system but before I took it out on a long run too...

Hi everyone, hope you all had a nice Christmas, despite of any car problems. I am going to change the front crank seal this week, has anyone got any tips for this job, I have read the instructions on the Rave Cd and on Range Rover net but just wanted to know any tips for getting the pulley...

Hi Everyone I am just curious If other people have had this done to their LPG tank. Basically the float gets bent up allowing more fuel in the tank. You only lose 5% of the capacity of the tank (for expansion). :D Matt Range Rover 4.6 Lpg Discovery 2.5

Hello Everyone Can anyone advise on a good battery for my Range Rover (4.6) I have seen various kinds but would like a good one for obviously the cold weather to come etc one with a good cranking output. Can you advise of any decent places to get one please. Any advice would be...

Hello everyone, I have a question, Does anybody know of a seller who does illuminated sill plates for the P38, I have seen many for the L322 model but can't find them for the P38. I would appreciate it very much, I know its a personal taste here but I do like the idea of these :D I do...