Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. T

    EAS Relay 20 query

    Hi all, I want to check operation of the EAS Compressor - read that bridging contacts 5 and 3 of Relay 20 should make the compressor run. I have Relay 20 off but the numbers are different : 30,85,86 and 87. Any idea which of these two are to be bridged ? Thanks
  2. T

    New Alternator 4.6 V8 Gems

    Hi all - thought this may be of use to some. Had my original unit ( Magnet Marelli 100 amp ) repaired Feb 2012 for £50 from a local repair shop. Failed early last week so took it off and went back to see him but he had shut up shop - cloud with a silver lining !! Went on to Ebay and found this...
  3. T

    Rev Counter and Speedo

    Hi all, I had to check fuses under the drivers seat for cigar lighter - after that there is no rev counter or speedo function . Also the radio code needs inputing each time the car is started. I have just checked fuse number 1 - that is fine as are all the others in that fuse box. P38...
  4. T

    My Magnet Marelli ( Lucas ? ) alternator

    Hi folks, I noticed my parking lights flickering and also the lights in the dash. The alternator light also came on a couple of times as did the "alternator fault " message on the display . I had cleaned the earth and live connections recently and got the following voltages on idle : 13.80 on...
  5. T

    CV Joint help please

    Hi Following on from my noise "down under " I have not been able to find the procedure for renewing the CV joint or any info re special tools if required or technique when doing the job. "dopey" reckons it is DIY able so I prepared to tackle it soon. Can anyone point me in the right...
  6. T

    P 38 - ticking / clicking sound from down under

    Hi, I get a sound from underneath when I take my foot off the accelerator - on all speeds over 20 mph. The faster I happen to be when I take my foot off the faster the ticking / clicking sound is. No sound when slowly accelerating or going up a slope. As per previous advice I removed the...
  7. T

    P38 transfer box and rear propshaft

    Hi folks, Following my earlier thread about transmission noise - wammer suggested front diff nose bearing - which will do soon. My mechanic was driving the car and reckons the tranfer box is suspect. What would make the noise in the TB when lifting off the gas ? Re rear propshaft I saw a...
  8. T

    HEVAC book symbol question

    Hi all, Wondering if anyone has had this and what was the reason. When starting up from cold there is no book symbol. A/C is off by the way - after a few minutes when the temp needle has moved up a bit into the blue zone the symbol appears. The various air vent switches do their job and the...
  9. T

    Grease nipples

    Hi all, Done a search but cannot determine what size the UJ grease nipples are - I will be replacing the UJ's and want to fit slightly longer nipples. Thanks
  10. T

    Transfer box oil - Dexron11D or Dexron 111

    Hi all, I want to drain/refill the transfer box- ( 1998 P38 4.6 Auto ) Local supplier only has ATF Dexron 11 not ATF Dexron 11D as recommended in my manual. Any one know the difference ? A search mentions Dexron 11 being replaced by Dexron 111 about 1995 - I have plenty of ATF Dexron 111...
  11. T

    EAS still hissing !

    Hi folks, Still getting the sound of an air leak from the front near side but have not been able to trace it . Tried a leak spray near the bag/airline/dryer - no bubbles. With the sound of the engine a bit difficult to pinpoint. I opened the front passenger door for something then the...
  12. T

    A front diff query and an EAS one

    Hi all, Following on from my "transmission noise " thread - thanks for input - wammers diagnosis re nose bearing - for the short term ( until repair sorted ) I have read here that removing the front prop shaft does not do any harm. With a lot less stress on nose bearing will I be able to...
  13. T

    Please help to diagnose my "transmission" noise

    Hi folks, First heard yesterday . A noise that increases in frequency depending on speed of the car. Starts at about 15 mph - whether in D, 3,2, or 1 - also happens when I coast along in N Does not happen as car is accelerating or driving up a slope - nor does it happen in reverse...
  14. T

    P38 electric head restraint u/s

    Hi folks, The drivers head restraint in my car is at the lowest position - pressing the "up" control has no effect - neither does cycling through up and down. I can hear a whirring sound though - so electric motor must be OK. What could have happened and can anyone advise how to restore...
  15. T

    P38 - aircon question

    Hi all, No cold air from the vents - was hoping one of you more knowledgable members could point me in the right direction. Have done the usual search and only partly successful. The compressor does kick in - and the thinner pipe from the compressor heats up quite quickly. It was...
  16. T

    P38 pillar/post interior trim

    Hi folks, After I remove the flaking "fuzz" from the interior trims I was hoping to source some sort of covering for them - I could leave them cleaned up and plain or try and cover them with new leather ( could be a pain ). Ideally hoping for some sort of "clip on " solution maybe to match...
  17. T

    Eas compressor seal replacement? Go for it !!

    Hi all, After a EAS fault I ordered a EAS seal ( with filters ) £20 off Ebay and an EAS Kicker Lite £69 from a UK based supplier. Just changed the seal,filters and reset the EAS - all functioning fine for under a ton ! And I have the EAS kicker for future use. No other leaks/issues apparent...
  18. T

    EAS manual overide

    Hi, Continuing on from a previous topic re EAS a couple of questions if anyone has had the experience : 1. rangerover.net suggests turning on the ignition to run the compressor ( bridging two pins on the disconnected ECU connector of the EAS) - what would happen if the engine was running? 2...
  19. T

    P38 - EAS Fault message

    Hi all, Had my first EAS "issue" this morning ! Only had the car a few weeks and getting an EAS lead with software etc was on my to do list -( or maybe some make of reset tool) plus doing a soap test and compressor refurb. I heard an "air hissing sound" yesterday evening - from the front of...
  20. T

    Code input instructions for HK please anyone !

    Hi, Well after my battery/alarm problems finaly got the EKA and after a few tries it worked - car starts . Both keys start the car and both fobs unlock the car. But only one fob ( no.2) locks the car. Not a great problem but would like to fix it - any suggestions ? Also had to get the...
Back
Top