what codes

gavbriggs · Jan 17, 2010

would you expect the engine to put up if the becm and engine ecu needed a resync?

i'm only asking cos some dumbass, who shall remain unamed, lost the scrap of paper i wrote it on.:doh::doh::doh:

p1692 or/and p1667 seem to ring a bell.

anyway met up with dave (davox) today to see if we could do anything about his car bieng deaders, seems like it needs a resync.
probably has the codes above when i managed to get em out with the elm327.

i wrote em on a scrap of paper and gave em to him, he'll prolly be along soon to confirm the codes he has!!!

or he might just be too embarrassed

j the range · Jan 17, 2010

p1667 p1672 it needs resync defo

gavbriggs · Jan 17, 2010

is that what they are j? where did you find that out?

j the range · Jan 17, 2010

the 20 times mine had it, hahahah thats why i got a sync mate

gavbriggs · Jan 17, 2010

did you mate, oh mate!

is it in the post?

have you found an engine? who's fitting it?

j the range · Jan 17, 2010

not in post i sitting looking at it, i will post it in the morn, not found engine all want two much for them, i got disco for now.

gavbriggs · Jan 17, 2010

nice if ya can afford it!!!

woogoo · Jan 17, 2010

P1667 is Anti-Theft Alarm serial link fault Drive cycle A:Signal out of range - below minimum. and the P1692 is Main relay fault. Short circuit to V Batt.

If this is of any use.

gavbriggs · Jan 17, 2010

kind of, as stated the codes were wrote down but the paper lost so really i'm guessing,

bieng as those codes sound power/alarm related it could be the cause of the issue??

woogoo · Jan 17, 2010

I know nothing about fixing but I'd be inclinded to replace the main relay or at least check it for obvious faults like corrosion etc., then re-charge battery. As if this is draining the battery then it would pull everything else down with it.

Just a thought.

eightinavee · Jan 17, 2010

A crap RF receiver.

gavbriggs · Jan 17, 2010

on a 2001? thort theyd sorted it by then?

eightinavee · Jan 17, 2010

No,it was well after production had ended,the first decent upgrade didnt get off the ground as the supplier went bust,took a while for the current YWY500170 to get sorted and come online - does the trick tho...

gavbriggs · Jan 17, 2010

it was ok for ages then went, i think it could be the 80 ah battery not upto job but not sure, till its fixed it wont run at all. i know someone has disabled the eka code.

j the range · Jan 18, 2010

gav if this battery is not up to it it will all be a waste of time, i agree with rf is the problem, i have sent him resync box to get him going.

what codes

gavbriggs

Well-Known Member

j the range

New Member

gavbriggs

Well-Known Member

j the range

New Member

gavbriggs

Well-Known Member

j the range

New Member

gavbriggs

Well-Known Member

woogoo

New Member

gavbriggs

Well-Known Member

woogoo

New Member

eightinavee

Well-Known Member

gavbriggs

Well-Known Member

eightinavee

Well-Known Member

gavbriggs

Well-Known Member

j the range

New Member

Similar threads