Series IIA speeedo-LWB 1966

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Qhriss

New Member
Posts
45
Location
The South
Hi-After the Range Rover debacle, have repaired the Series IIA but find the speedo is knackered. I currently need the clock cw cable plus the end bit that goes in the gear box ( with three tiny screws ) as everytime I bought sepperate parts-one didn't fit with t'other :mad: S:mad:o anyone can help ? Can pay by Paypal / card ect, cheers Q
 
The screws from an old lift pump if you have one will fit the box I used this method, as the screws are a tad too long I put a nut on them to tighten up to the box.

Andy.:)
 
The screws from an old lift pump if you have one will fit the box I used this method, as the screws are a tad too long I put a nut on them to tighten up to the box.

Andy.:)


or you could put a nut on the screw, cut screw to required length, run nut up to flush with end of screw, file end of screw flat and finally use the nut to clean up any burrs stil left. that way yer dint got a long screw sticking out which is likely to snap orf.

and I still int had time to get yer speedo orf. hopefully this weekend
 
Back
Top