Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. SpaceDawg

    Defender 90 For Sale

    Hi, I'm selling my 1990 Olive Green (not MOD) Defender 90 200TDI which is on a galvanized chassis. It's done about 140k on the original engine, runs fine with no issue. The good bits are; The bodywork was completely resprayed during its re-build about 5 years ago. Galvanized chassis, perfect...
  2. SpaceDawg

    For Sale Light bar and farm jack

    Hi, I have a light bar with 6x18w cree LED on it, its never been on my 90 £60. Also a farm jack £30. I'm near cowfold west sussex.
  3. SpaceDawg

    Disco 3 (LR3) Glow plug removal

    Hi All, I'm trying to do my glow plugs, but I'm a bit stuffed for access to them, you can see in the picture how far I have got, do I need to remove the black box circles, if so how? I'm assuming I do. Also, you can see on the left circled the glow plug harness connector, do you just pull...
  4. SpaceDawg

    Bleeding air

    Hi, Recently had my 90 200tdi in a garage for an MOT and they replaced one bleed off pipe and nipped up (apparently) all the injection pipes to stop a small leak on no 1 cylinder. Now it takes a while to start, I'm assuming there is air in the system. I have taken off the the fuel filter and...
  5. SpaceDawg

    Nipple

    Hi All, My 1990 defender has lost it windscreen washer middle nipple (sorry that the only way I can describe it) so at the moment the water squirts onto the tyre on the bonnet. Any clues where I can get one from?
  6. SpaceDawg

    Two tyres for sale and a radio

    Hi, I'm replacing the tyres on my 90, the spare and front two are at the legal limit. However, a couple of year ago I put 2 new 235x85x16 Khumo KL71 on the back they have probably 10mm+ of tread on them. I'm looking for £80 for the pair. I'm in west sussex. Also I have a rario I got for my...
  7. SpaceDawg

    Disco 3 (LR3) Recommendation for code reader

    Hi, I'd like to by a code reader now I'm a Disco 3 owner, just wondered if anyone here has experience on anything other than a hakweye? Ta
  8. SpaceDawg

    Happy Birthday Jo (the 90)

    I thought I'd put this up Jo is now 27 year old 90. Over the past 5 years this is what has been done to Jo. Galvanised chassis New bulkhead New rear tub All other panels repaired or replaced Respray Then I got Jo when my mate Mick died, then New rear diff, bearings, springs, shocks, drums...
  9. SpaceDawg

    200TDI Coolent Flush

    Hi All, I'm going to run some ceramic block sealent into my 200TDI, is has a slightly porous block. Just wondered what is the best way to remove 100% of the antifreeze in the system. I was thinking of removing the bottom hoses drain, stick a hose in the top of the filler and turn on, keep...
  10. SpaceDawg

    Screws, Flaps, Rubbers and Wetness

    Hi, I'm trying to get Jo (90) sorted for the winter and one thing on the list of tasks is to find replacement screws for the dash cover, you know all the plastic parts. Does anyone know the size of the screws, I've google it but you seem to be able to get kits for everything but not the dash...
  11. SpaceDawg

    The mistery of the water system, no pressure

    Hi, Ok just chucking this out there, not because I have a problem with it, but to see your views. Its my 200TDI, it runs pretty cold just over the upper dot on the temperature gauge and on a motorway run after 30mins+ at 60+ it creeps the halfway up the gauge, no further. I have no leaks. I...
  12. SpaceDawg

    Me fuel pump gave up

    My fuel pump was dripping a bit over the last couple of months, so I left it in place for a while being lazy. However, it pretty much gave up, the car was running but I though I best change it. Look at the video do you think I made the right choice?
  13. SpaceDawg

    LED Headlamps

    Hi, What a minefield this is, went to the LRO show and there were LED headlamps from £120 - £600! So I did not buy any :-( All I want is a set that will go into the origional mountings and work off the origional wiring, nothing fancy just a little brighter than my current headlamps as winter...
  14. SpaceDawg

    200TDI Snorkel Recommendation

    Hi, As the title suggests I'm looking for a snorkel for my 200tdi, however my 90 does not have a hole in the wind where some of the snorkels I have looked at screw into. It does however have the standard air box (big metal drum). Just wondered if anyone had a recommendation as to which one to...
  15. SpaceDawg

    I think my 90 is up at the front!

    Hello, Just wondered if anyone can measure from the ground to the bottom of the wheel arch on there 90 for me. Mine seems to be sitting a little high on the front and its bugging me, I'll put a photo up later. I have 235 x 85 on mine so the measurements can only be from the same size tyres...
  16. SpaceDawg

    Dipstick 200tdi

    Hi, Had a look through the archives and it seems this issue has happened a few times. But just to be sure. I changed the engine oil and filter yesterday, put in 5ltr of oil and the dip stick was reading between Min and Max? The manual says it should be 6.85ltr of oil and filter. Just wanted...
  17. SpaceDawg

    Defender heater box cables

    Hi All, Ok todays job is to look at the speedo and the heater box as I have never had goog heating and I managed to pull the speedo cable out. The speedo is fixed hence the title being about the heater box. Ok it has two cables, on on the top with I think directs cold air into or around the...
  18. SpaceDawg

    200tdi cracked block?

    Hi, Ok I think I have a leak on the right side of the engine where the manifold is, between two of the core plugs, as anyone ever heard of this before?
  19. SpaceDawg

    200tdi Rev Counter Alternator post

    Hi, I have a A127-45 Autonator on my 200TDI, just wondered is any of the connections below are the W connector I need for a Rev Counter?
  20. SpaceDawg

    Couple of quick questions on the Electrics of a 200TDI 90

    Hi, Now I have plenty of room under the bonnet of the car I noticed the main power from the battery goes to what looks like a distribution post on the started motor. I assume it will be ok to run another lead from there to a small fuesed distribution box on the bulk head for my spots, roof bar...
Back
Top