Search results

Rarely used ozpig, had it 12 months and used it about 5 times, complete with 2 extra chimney pipes with the two included hot plates and carry bag. The lot cost me £300 Any sensible offers before it goes on eBay

Thinking of doing the Florida Strata over a few days this summer, I've done the search and can't find all the info I need so: I was going to go alone with the lad in one vehicle, on a dry warm few days, are there any obstacles that would hinder me? Any where I would need a tug out? I'm in a...

Pulling my 1500kg shed my 300 is appalling, gearing down does not help, holds speed better in higher gear. Another prob am getting is grey smoke on a cold startup. I have fitted a new lift pump and filters, checked ip diaphragm. What I have found is a fresh supply of air in the diesel...

Iv got no power on slight inclined when pulling my 1500kg shed. If I keep the revs low it fairs better than gearing down and using revs, there is no smoke of any description when under load. I'm hoping that the diaphragm is stuck but having read a brief guide on another forum I dare not go in...

My 300 has just had a new head under warranty for a poreus head. Symptoms were blue white smoke on startup. Diganosed with oil on injector and glow plug then confirmed by a specialist. Got the car back and it's still puffed white smoke this morning, starts fine but when revved it smokes for 10...

My 110 has the self levelling unit on the back. I have changed all the springs for tdci spec all round so the back now sits a little higher and the springs are heavier duty as they are for a 110 without self leveller. Has anyone any experience with the self levelling unit? Can the height at...

Any body messed with the adjustment pot on this relay? Is it a low voltage adjustment.? Reason I ask is that the £10 relay would make a good low voltage cut off but the cut off voltage is too high, there is a pot but before I go messing wondered if anyone had given it a twist. Can't...

Where do they go? Can someone measure me a point of reference please foe the holes for the side steps on the back doors, there are no clue with holes etc so I need to drill my own. Cheers

Does anyone know the procedure for this? I have read some posts detailing mods to the loom behind the switch but I'm not a fan of hacking looms. I do have a rear door loom from a 2009 tdci which has a relay in it and I don't mind hacking that to fit the existing loom at the rear corner, but...

Iv had my 300 def since Xmas, noticed whit/blue smoke on startup. Low and behold when I've had two garages look at it, warm weather and no smoke. Just investigated myself and found a really Oily glow plug, checked the same injector and thats dripping in oil too the full length of it. Im...

Under what conditions should the Wastegate move? By hand with the actuator attached? When revving? Or is it just under load and when detached? Cheers

I have been filling propane bottles up for a few years and know the safety issues before the lectures start. The garages are becoming more keen and refusing service so I'm looking at fitting an auto gas filler to the outside with a pipe to a gas bottle within the car, therefore looking like...

I know it's been done before I've done the searches, I've seen the RDX items and the OEM stuff. I would like to see pics of other peeps stuff that are none of the above, the acoustic properties of the plastic trims don't inspire me, I fancy something in mdf but would like some ideas. I also...

Anybody used one of these? Are they noisey due to movement in the receiver? Plan is detachable tbar and steering guard with detachable whinch that fits both. Any views from experience would be much appreciated.

My drivers door will not power my lghts, any ideas please? Just had the factory alarm bypassed and another fitted and wondered if this was the cause as the earth point does still work for the alarm. Thanks in advance

Im sure it's been discussed before but again I'm struggling to find it. Been in two 300tdis within the past few weeks, one a 95 with 50k and the one I bought, 97 with 80k. Mine seems a bit rougher and noisier and not as smooth. Mine has more in the way of carpets. Are there any...

Iv done a search but can't find any answers. Hopefully someone will know Will the early door cards fit the later type doors? Will the keep fit window winders from the same early doors fit the late style doors? Thanks

Just wondereing if i could buy it anywhere in S/Yorks filtered and de-watered. I know i could get and filter my own but i haven't got the time patience or space. Iv got around 150l of used stuff thats been sat waiting to be filtered for over 6 months but no time to do it. I have someone...

Hi folks. Tranny box is n the rag. Its leakng ut of the intermediate shaft oil seal. I know this is a simple O ring, and from what i can see this s secured with one nut from the rear. Question is can i change the ring without taking the whole box to bits just by undoing the nut, tapping it...

Hi guys. Iv searched till im blue in the face but all pics i have seen pint to it being not a straight fit. Or not at all. But i have read a post on a forum from someone saying they have done it with no further details. Can it be done? Is it straight forward? I think the puma wheel...