Recent content by MartinBird
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
M
Thanks for replys it is appreciated.
Sorry for delay in responding.
Im leaning that way too. I checked the pressure valve by the compressor to check it wasn't blocked, no worries there.
I dont suppose there is a way to check the compressor? Its running i know that much but maybe if it is...
-
M
Hi everyone.
After some advice and help.
The wifes Range rover seems to have developed a problem with the air suspension. No warnings on dash but the suspension will not go from low mode to normal or off road mode by selecting the switch on the dash. It will flash and tell you that you...
-
M
Sounds like u/j's or A frame ball joint..........
-
M
Cant beat the taste test as horrible as it is!
-
M
Why not fix the fault?
Or get someone to take a look.
With the money and hassle you spend swaping the master cylinder and getting new brake pipes made up, it may only cost an hours labour.
If however your minds made up, then the only parts that should need changing are the...
-
M
Do they have drain tubes fitted on them? Check they are not blocked.
Try vaseline on the old seal.
-
M
Drive a few more see if they all do it!
-
M
best route is to go to a custom exhaust place like powerflow or longlife, they will make you a replacement in stainless steel at a fraction of what Overfinch will charge.
Plus, they give a lifetime warrenty on their parts.
-
M
Heres a before and after on my discovery
took me about a days work........ A pain in the arse, yes, but the end result is a good one.
Both my lights were off ebay at about 50 quid each both were leaking water into um. so i resealed um. had to get one of the under trims from Land...
-
M
take your hoses off and take them along with the radiator to a hydraulic fittings shop like Pirtek, they will either make you some new hoses with the correct ends or provide you with an adaptor type union.................
-
M
Yes mate, this is correct although i thought it was 5mph.....
-
M
its only goota have a diode in it.........
-
M
any machine shop can skim a head, look through a yellow pages for engine reconditioners and that should sort you out!!!
-
M
I think a decent make head gasget should do the trick, clean the block and head up and fit a new one, its up to you but it maybe worth getting the head skimmed whilst its off.
-
M
dunno if this ones the same year but follow this link and have a read
http://www.landyzone.co.uk/lz/f8/300-abs-light-27043.html