series 3 clutch
- Thread starter oggyv8
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
andyb66
Well-Known Member
- Posts
- 1,795
- Location
- Middle of Salisbury Plain, Wiltshire
Series clutch. Bolts straight on and the centre splines match your gearbox. Always the way I have done it.
- Posts
- 83,296
- Location
- Embasinga stocæ
I always thought that, as a general rule, the clutch had to match the flywheel, and the clutchplate had to match the gearbox input splines - ie 200TDi clutch with a series clutchplate.
andyb66
Well-Known Member
- Posts
- 1,795
- Location
- Middle of Salisbury Plain, Wiltshire
Yes thats what I meant.
IIRC with V8 conversions into a Series you drill the flywheel for the Series clutch cover.
dr pepper
New Member
- Posts
- 1,438
- Location
- lancashire
I concur, use the clutch for the box, another thing to look for is the pilot bearing in the flywheell its a phozy bronze bush, make sure the one you use fits the input shaft on the 'box.
- Posts
- 83,296
- Location
- Embasinga stocæ
If yu start drilling the flywheel, you should get the complete flywheel re-balanced - it is a critical mass (sic) and must be balanced correctly, or it will shake the engine to pieces.
with the pilot bearing, make sure the hole is the same size as the gearbox spigot.
with the pilot bearing, make sure the hole is the same size as the gearbox spigot.
fenby1976
New Member
- Posts
- 1,036
- Location
- West Wales
Is there a difference between a series petrol and deisel clutch please as i am putting a 200 tdi into a series and some advice says use series clutch,others say disco clutch,thanks,Mark
I've done this conversion myself. I used a disco 200tdi clutch cover and spigot bearing with a series III clutch plate and clutch release bearing. The Disco clutch plate will not fit because the splines do not match the series gearbox input shaft. I used the Disco clutch cover because it is designed to cope with the torque of the Tdi and it is compatible with the series clutch release mechanism. Series III 2 1/4 petrol and diesel clutch components have the same part numbers. I think on the II/IIA Land-Rovers there was a difference between clutches on petrols and diesels. I have a feeling that a 9" clutch was used on the petrols and a 9.5 " clutch on the diesels.
Last edited:
jai_landrover
Well-Known Member
- Posts
- 13,392
- Location
- Luton
Pretty sure the so called HD clutch for a TDI is just a diesel clutch plate from a series anyway Me thought might be wrong. Wasn't the difference 9 inch or 10 inch clutch plate/cover?
nope, HD clutch is usually same as fitted to 130s - 8 spring
