range rover alarm

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
H

hunterandthehunted

New Member
Posts
224
hi,

could someone help me with the alarm please. all is working fine apart from audio. i dont know nothing about the car as i have only just purchased it.
there are loads of issues with this car and i am hoping you guys can help me out.

thanks
 
hi welcome to the mad house what rr have you got and when you say all is working fine apart from audio do you mean alarm not going off? j
 
hi,

yes sorry, i should of explained it better. the alarm and immobiliser is actually working but when i tried to set it off by waving my arms about, i get the motion detected message on the dash but no sound. i also do not get any sound when the indicaters blink when arming or disarming.

i have a 1995 4.6 hse and i dont think its a good one...

thanks
 
the alarm, i think, doesnt 'advertise' its set by making a noise, at least mine doesnt, the noisy bit is under the fuse box in the engine bay!
 
thanks

is it relatively easy to remove and replace, thats asuming thats the problem.
also another thing i noticed today whilst looking around the wheel well area
was that there are 3 big holes which looks like there was some kind of grommet
in them. they have rusted through and i would like to nip that in the bud fairly
quickly so the rust does not get a hold on the car. are these replaceable? whats the best way to stop the rust from spreading?

thanks
 
Last edited:
i got an idea, leave a door open and lock it/set alarm.

also to set the alarm its a double press on the fob are you double pressing, make sure indicators flash 3 times!!!
 
i basically tried all that already, motion detecters kick in but no sound. are the indicaters supposed to continuously flash as well. i definately am getting the alarm to go off but cannot get thee damn thing to make a sound?
 
which well is it?

hoe big are the grommits, to repair the metal, rub it down/wire brush it, the get some of that rust stop type chemical rust remover and then spray it with a rust inhibiting primer, then paint to match the body! should make a thorough job of it!
 
spare wheel, the holes are quite big , i was wondering if they are replaceable.

the grommets that is, thats if it was grommets, the holes are perfectly round with some remenance of rubber
around the outside, but was metal on the inside. hope that makes sense
 
Last edited:
mine has the same holes and rust, i believe someone banged the gromits out for the lpg pipes etc, obviously they are there to get rid of any water that might pool but i would assume they can be got from somewhere like a fstner supplier or seals and bearings shop.

there is a place in sheffield that supplies seals, city seals and bearings. i reckon a call to them with the hole size and they'l prolly post em out to ya or i could pop in and pick em up. theyre not far from me!

Rubber Grommets has them but they are open grommits

you may be able to get hold of em from a scrappy!
 
You must log in or register to reply here.

Similar threads

K
Range Rover HSE 2020 year
Replies
9
Views
784
Graculus
Graculus
A
Range Rover L322 - not turning over
Replies
12
Views
2K
gold rover
gold rover
A
P38A Head bolt removal question
Replies
6
Views
407
AndyF07
A
F
Trans failsafe program
Replies
11
Views
2K
roythebus
R
J
Range Rover sport shocks
Replies
9
Views
428
pwood999
pwood999
Back
Top