(Possibly) dumb welding question...

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Clarky130

Clarky130

New Member
Posts
3,957
Location
Chippenham, UK
I know you have to disconnect the battery to weld, but I've also seen disconnection of the alternator advocated...

Is this needed... Or even just prudent? I've fried a voltage regulator before, in the dim and distant past... But that was 'cos I was stoopid and forgot to disconnect even the battery! :doh:
 
It's always better to be safe than sorry and for the time it takes i always disconnected both to be on the safe side.
There is a one way diode in the alternator that can blow if high current is forced through it.
 
ive never dissconnected anything either....always get a good clean bare metal earth near where youre welding , it makes the welding better anyway. having got modern enough to have radio codes, id be wary of upsetting immobilisers by dissconnecting the battery but havnt had that issue myself. quite wtat happens when youve got puters and lectronics everywhere is anyones guess though.
 
I normally undo the battery +ve, and keep the earth close to the welding point, didn't have an issue in 8 hours straight welding ....
 
Mig is such low voltage(50v on a good set vs the kv spark pulses off a petrol engine) I dont really think its necessary if you have clean earths, but on electronic laden cars I do disconnect the negative just in case the old tail may be true
 
Wait so do you remove the negative or positive :eek: I'm just hijacking as I've got no clue and all the welding I've done has been off the vehicle or on the series I just took the battery out but on a disco the alarm will sound etc
 
Dr_evil said:
Wait so do you remove the negative or positive :eek: I'm just hijacking as I've got no clue and all the welding I've done has been off the vehicle or on the series I just took the battery out but on a disco the alarm will sound etc
Click to expand...
if you switch ignition on then remove earth clamp within 15 seconds alarm wont sound
 
Welding manual says to disconnect the battery and the alternator. Its up to you if you want to take a chance. I fried an alternator on a VW T25. I disconnect both terminals. Belt and braces approach for me.
 
Modern Mig welding shouldn't be a problem...

I've had trouble welding with Arc, but that was a long time ago and the wiring on the Triumph was shot anyways. :(
 
FWIW disconnect battery negative as a minimum. On more modern vehicles I would advocate disconnecting ecu's as many are quite sensitive. Just made that mistake on my RRC, although battery disconnected EFI ecu has developed a fault - could be a coincidence but I suspect with the amount of welding I have done I have fried the ecu. Good job I have a spare!
 
when doing the back end i dont disconnect anything but when doing the inner wings i whipped off the neg battery connection just to be sure and i have spend many an hour mig-ging the disco now and no obvious problems so far.
 
You must log in or register to reply here.

Similar threads

Flossie
Old car electrical question.
Replies
2
Views
731
J_D
J_D
R
Freelander TD4 starting problems
Replies
8
Views
1K
Nodge68
Nodge68
currymunster
Disco 1 Electrical Gremlin!
2
Replies
30
Views
3K
mystery
mystery
D90 Td5
Defender Td5 Battery Warning Light
Replies
5
Views
2K
miktdish
miktdish
MikeFl4
P38A ABS Fault and Traction failure from ignition II
3 4 5
Replies
87
Views
11K
Grrrrrr
Grrrrrr
Back
Top