P38 4.0 1997 won't start after Chinese !!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
simp212

simp212

New Member
Posts
88
Location
Dunkeswell
Hi guys I'm sat at 1:38 in the morning by the sea in Devon awaiting the aa after popping to get a takeaway! I locked the p38 came back unlocked it by the key went to start and nothing!! Thought maybe hadn't left it in park or neutrul but it was! Iv jumpered the starter and fuel pump and they run iv even left key in pos 2 and jumpered starter motor bit nothing it won't run! Iv tryed the emergency key thing and the rangie beeps at me ect to acknowledge it's worked but nothing! Any idears guys?
Cheers Si
 
Hi yes ud think it was immobilised but no message on dash and iv entered the EKA and got the confimation beeps from alarm but nothing... at a loss the strange thing is the check engine light hasnt come on now i know that this comes on 48ms after code has been read from key...
 
no doest clunk at starter iv power probed the starter and it turns the engine over and iv probed the fuel pump and that runs so starter and pump ok :( its as if it immobilized but no message on dash ect the only thing that dosent happen is the check engine light...
 
it sounds like out of sinc but it could be as easy as bat down a bit have a look at earths in engine also leads to starter. when mine goes out of sinc it turns over but wont start i dont get message on dash
 
Hi update have managed to get her to crank by power probing a negitive to bcm out put the. For a short while I'm able to crank her on the key! I'm suspecting a crap batterey not sure yet tho it's on charge! How do u resync it then?
 
you will need rovercom or such like its yor becm out of sinc with ecu. have you got a code reader? if you haveplug it in you will get 2 codes p1667 p1672 thats out of sync
 
thats the one. its bad when you affaid to wash the fecking thing. at least now i got sync mate i can go out of the road in it
 
ha iv tried and tried it just wont do anything.... i just dont get it it new battery fobs lock and unlock doors can activate starter from bcm pin out can operate fuel pump.. no error messages in dash ign sends 0v to bcm when in posistion 3 im lost its stuck half way across the drive lol
 
simp212 said:
ha iv tried and tried it just wont do anything.... i just dont get it it new battery fobs lock and unlock doors can activate starter from bcm pin out can operate fuel pump.. no error messages in dash ign sends 0v to bcm when in posistion 3 im lost its stuck half way across the drive lol
Click to expand...

you need someone one with a rovacom or similar kit,where abouts are you, dunkswell,where's that??.
 
You must log in or register to reply here.

Similar threads

I
P38 BeCM locked?
Replies
8
Views
886
pwood999
pwood999
K
P38 2.5TDI won't start
Replies
8
Views
746
Kelvin'D-MiC'
K
F
P38A Starting issues.
Replies
7
Views
756
kermit_rr
kermit_rr
DollyBird
Engine disabled, keys not working, tried the guide “Re-synching the Range Rover P38 diesel engine with the Solved - BECM using a Nanocom” no luck
Replies
9
Views
1K
DollyBird
DollyBird
Louis2.5DSE
P38A P38 DSE fires but won't start
2 3
Replies
58
Views
6K
BDC
B
Back
Top