Help please

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
C

Chrisnick

New Member
Posts
19
Location
Beverley nr hull
Hy new to this forum and would like some help the problem I have got is I have a dicovery 300tdi 97 p plate when I start it up there is a gravelly/rattley noise coming from it but if I rev the engine or depress the clutch it go's if I then turn off and restart it its ok it only seems to do it when it's been stood and cold thanks for taking the time to read this

Regards chris
 
Hi, Chris...some questions to know where to start

1. Is the engine oil level good?(what oil and when did u replace it) ....if the level and the oil are OK, after the cold start does the oil pressure lamp extinguish instantly?

2. When did u replace the auxiliary belt?
 
Last edited:
sierrafery said:
Hi, Chris...some questions to know where to start

1. Is the engine oil level good?(what oil and when did u replace it) ....if the level and the oil are OK, after the cold start does the oil pressure lamp extinguish instantly?

2. When did u replace the auxiliary belt?
Click to expand...

hi oil level seems to be ok i have only just bought the vehicle so was planning on getting an oil change

chris
 
Chrisnick said:
hi oil level seems to be ok i have only just bought the vehicle so was planning on getting an oil change

chris
Click to expand...

If the oil pressure lamp goes off right away after u started it u have no probs there...question nr 2 was cos it could be a play in one of the pulleys which dissapears after the aux. belt turns it a bit.
 
Last edited:
sierrafery said:
If the oil pressure lamp goes off right away after u started it u have no probs there...question nr 2 was cos it could be a play in one of the pulleys which dissapears after the aux. belt turns it a bit.
Click to expand...

I really appreciate your help but I'm not very technical I thought there would be a simple answer some one said it sounds like the thrust clutch bearing but it looks like I'll have to take it to a garage which sounds expensive
 
Chrisnick said:
some one said it sounds like the thrust clutch bearing
Click to expand...

Ok m8...could be that too....first of all put a fresh oil in it and see what happens.......anyway if it's just on cold start it's useless to go to a garage now cos there it wont be cold start again;) ....... if its some play in a pulley it will degenerate in time and will be easyer to diagnose.....good luck
 
If it goes by depressing the clutch as somebody has already said it could be the clutch thrust bearing,my dad used to have a transit that did the same after being stood.
Try pressing the clutch in before starting after it's been stood to see if you still have the noise then.
 
Last edited:
Chrisnick said:
Hy new to this forum and would like some help the problem I have got is I have a dicovery 300tdi 97 p plate when I start it up there is a gravelly/rattley noise coming from it but if I rev the engine or depress the clutch it go's if I then turn off and restart it its ok it only seems to do it when it's been stood and cold thanks for taking the time to read this

Regards chris
Click to expand...


No disrespect intended but it sounds like you are new to the wonderful world of Land Rover?

If the noise is only there on early cold morning starts I would worry about it too much, especially as it is not apparent if you depress the clutch. Incidentally, on early morning starts, you will help your engine if you depress and hold the clutch whilst starting the engine - release it once the engine has started.

It sounds like you have a slightly worn clutch thrust bearing, but cars will run for ages before giving you a problem - normally.

I only point this out as it is not a small job to replace this item as the gearbox and engine must be separated, which takes man-hours. Also, it is prudent to replace the whole clutch whilst the 2 are separated - quality clutch kits cost about £85 so that's not too bad but the labour charges will not be cheap.


Good luck

Dave
 
sierrafery said:
Hi, Chris...some questions to know where to start

1. Is the engine oil level good?(what oil and when did u replace it) ....if the level and the oil are OK, after the cold start does the oil pressure lamp extinguish instantly?

2. When did u replace the auxiliary belt?
Click to expand...
Sorry sierrafery but what the f£ck has either of those got to do with this problem :confused: :confused:
 
Hy new to this forum and would like some help the problem I have got is I have a dicovery 300tdi 97 p plate when I start it up there is a gravelly/rattley noise coming from it but if I rev the engine or depress the clutch it go's if I then turn off and restart it its ok it only seems to do it when it's been stood and cold thanks for taking the time to read this

thebiglad said:
No disrespect intended but it sounds like you are new to the wonderful world of Land Rover?

If the noise is only there on early cold morning starts I would worry about it too much, especially as it is not apparent if you depress the clutch. Incidentally, on early morning starts, you will help your engine if you depress and hold the clutch whilst starting the engine - release it once the engine has started.

It sounds like you have a slightly worn clutch thrust bearing, but cars will run for ages before giving you a problem - normally.

I only point this out as it is not a small job to replace this item as the gearbox and engine must be separated, which takes man-hours. Also, it is prudent to replace the whole clutch whilst the 2 are separated - quality clutch kits cost about £85 so that's not too bad but the labour charges will not be cheap.


Good luck

Dave
Click to expand...
No **** sherlock the clue's in the original post :doh: :doh: :D
 
oldskool said:
Hy new to this forum and would like some help the problem I have got is I have a dicovery 300tdi 97 p plate when I start it up there is a gravelly/rattley noise coming from it but if I rev the engine or depress the clutch it go's if I then turn off and restart it its ok it only seems to do it when it's been stood and cold thanks for taking the time to read this


No **** sherlock the clue's in the original post :doh: :doh: :D
Click to expand...

There was no need for that. He said he was new to the forum not LR's. Also I don't like assuming anything.

However I don't need to assume that you are an angry little shît - I now know.
 
thebiglad said:
No disrespect intended but it sounds like you are new to the wonderful world of Land Rover?

If the noise is only there on early cold morning starts I would worry about it too much, especially as it is not apparent if you depress the clutch. Incidentally, on early morning starts, you will help your engine if you depress and hold the clutch whilst starting the engine - release it once the engine has started.

It sounds like you have a slightly worn clutch thrust bearing, but cars will run for ages before giving you a problem - normally.

I only point this out as it is not a small job to replace this item as the gearbox and engine must be separated, which takes man-hours. Also, it is prudent to replace the whole clutch whilst the 2 are separated - quality clutch kits cost about £85 so that's not too bad but the labour charges will not be cheap.


Good luck

Dave
Click to expand...

hi it turns out that it is the clutch thrust bearing so ive decided to keep running the vehicle cos the clutch is fine and if it go's ill just get it replaced then thanks for all the help, im sure ill be back with more questions;)

cheers chris
 
You must log in or register to reply here.

Similar threads

T
Whats this noise? Help please
Replies
10
Views
753
Henry_b
Henry_b
usna87
LT230 grinding noise?
Replies
7
Views
516
usna87
usna87
D
Spiggot bearing question
Replies
11
Views
753
David g4yvm
D
A
Defender 300tdi ticking noise
Replies
7
Views
461
Aydencj
A
B
BUYING A LANDROVER THIS WEEKEND ADVICE PLEASE
Replies
3
Views
478
marksman
marksman
Back
Top