Help Fat fingerd so & so has broke it

Hi,
Does anybody have any idea where i can get
The little plastic clip that holds the Clutch slave cylinder rod into
the fork cos some ham fisted git has broke it

Pete, recently I managed to break two of those trying to refit them. I found spares on ebay. However rather than keep breaking them I cleaned the fork seat and pushrod ball end and stuck it in place with a dab of silkaflex and supported the rod overnight on a rag while it cured. Slave fitted fine the next day.

Lots of various forum posts by those who say the clip is only there for slave refitting and bleeding. It isn't necessary afterwards. If it were it would be much more substantial.

Thanks
i will give the sikaflex a go if i cant find one
if anybody has a spare it would be greatley appreciated

you dont even need to stick it ,just hold in place whilst you fit slave ,but google frc3327 for a new one

jamesmartin said:

you dont even need to stick it ,just hold in place whilst you fit slave ,but google frc3327 for a new one

Click to expand...

Thanks for the part number James a fountain of knowlege as always

Pete I have one I didn't try and fit going spare. See if you can Pm me your address and I'll Wang it in the post to you tomorrow.

On it's way Pete. BTW, my local landy garage install them using v long nosed crank-ended needle-nose pliers. Lightly pinching together the locking clips as the clip is pushed against the fork. Im guessing using a short length of pipe slipped over the pushrod.

You may want to warm the clip up in some boiling water first to make the tabs more pliable - they dont like brute force when cold....as i have found...

as jamesmartin says, you dont necessarily need to stick the pushrod to the fork, but when I tried the hold-in-place-and-slip-the-slave-cylinder-over technique I obviously mis-located the pushrod as after bleeding and testing the pedal there was a clank and a cylinder full of DOT4 dripping out of the bell housing drain hole I wanted to make sure the next time.

Thanks ,very much appreciated
i snapped it using my fat fingers
Will hopefully be getting it back together
As soon as i get 5 minutes

you could also use a zip tie

80p for 90-110 & Defender Clutch Slave Cylinder at www.rimmerbros.co.uk