fabrication
- Thread starter sean1970
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I've used paper clips and cut down bits of plastic to shove in on my cars so it should work on yours although I've never tried a modern one.hi all does any one no if it would be possible fabricate a key? out of some sheet tin to use to remove the stereo from my 03 fl v6
- Posts
- 83,296
- Location
- Embasinga stocæ
last time i had that prob - went and spoke nicely to lad at halfrauds - he came out with their tools and loosened the rad for me - worth a try?
G13SJC
New Member
- Posts
- 735
- Location
- Nuneaton, Warwickshire
Or you can make your own from an old bank / AA / Tesco card.
I'm guessing you have the satnav stereo?? With two rectangular slots to each lower corner??
If so - cut the cards into two thin wedges say 5mm at one end going to 15mm at the other.
Insert the smallest end into each rectangular hole and then try and grip the radio and pull towards you. (not by the cards obviously).
If this does not retract the retainers, then try again after cutting a small part off the 5mm end (ie cut it off at say 7mm).
This worked for me when removing my Freelander OE system.
Regards,
Steve
I'm guessing you have the satnav stereo?? With two rectangular slots to each lower corner??
If so - cut the cards into two thin wedges say 5mm at one end going to 15mm at the other.
Insert the smallest end into each rectangular hole and then try and grip the radio and pull towards you. (not by the cards obviously).
If this does not retract the retainers, then try again after cutting a small part off the 5mm end (ie cut it off at say 7mm).
This worked for me when removing my Freelander OE system.
Regards,
Steve
Alan C
Active Member
- Posts
- 263
- Location
- Hatfield, Hertfordshire, UK
JonFre
Active Member
- Posts
- 557
Has the sat nav packed up?
Similar threads
Freelander 2 (LR2)
Freelander 2 Stereo replacement (5 inch screen)
