DeepEndLearner
Member
- Posts
- 54
- Location
- Gloucestershire
After reading the besian vanos repair. I'm peering into the vanos the outer teflon ring is green. Is that factory original hasn't been updated?
It says the vanos needs to be pressed so metal pinches up against the plastic and does not rotate. One can fit the tip of the engineer pick the other can slide paper in. Both do rotate.
Is it safe to assume these need replacing?
Also the instructions says to mark vanos before separating because it was factory balanced... one fell out on the table how important is this balancing? Oops
It says the vanos needs to be pressed so metal pinches up against the plastic and does not rotate. One can fit the tip of the engineer pick the other can slide paper in. Both do rotate.
Is it safe to assume these need replacing?
Also the instructions says to mark vanos before separating because it was factory balanced... one fell out on the table how important is this balancing? Oops