Another P38 not starting

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
bazzasglovers

bazzasglovers

Member
Posts
40
Location
Hinckley, Leicestershire
My 2001 4.0 decided not to start this morning after being fine last night,turns over ok but that's all.
Called AA and pointed them in the direction of the crankshaft sensor but found this to be ok(after removing it and checking it)
After a few hours checking various things there is no spark at the plugs and no fuel getting through presume this is linked to maybe an imobiliser issue although remote unlocking etc is working fine.
Oh and on holiday in mid Wales so will be a recovery home on Monday.
Grrrrrrrr
 
Just out of curiosity do they carry diagnostic equipment that will work on Land Rovers/Range Rovers or just basic OBD readers
 
bazzasglovers said:
My 2001 4.0 decided not to start this morning after being fine last night,turns over ok but that's all.
Called AA and pointed them in the direction of the crankshaft sensor but found this to be ok(after removing it and checking it)
After a few hours checking various things there is no spark at the plugs and no fuel getting through presume this is linked to maybe an imobiliser issue although remote unlocking etc is working fine.
Oh and on holiday in mid Wales so will be a recovery home on Monday.
Grrrrrrrr
Click to expand...
Save you money on fuel though.don't think it would crank if its imobilised,do you get engine disabled message on the dash? I guess the AA checked the inertia switch.
 
One check I seem to remember from my Mg forum diesel engine days which was to put sensor in plastic bag in freezer for an hour and then see if it worked, if so was deemed f.cked, but don't suppose many AA vans have a freezer on board
 
Yes, Thor will crank no matter what. If the code between the BECM and engine ECU has become mismatched, then you will get it cranking over but not starting.

What were the faults that were shown in the ECU?

I have Syncmates for rent which will plug in and resync the BECM/engine ECU if they have mismatched codes.
 
20180826_105417.jpg
Don't know if this helps but this is what the AA diagnostics came up with!!
 
You must log in or register to reply here.

Similar threads

D
L320 TDV6 multiple issues at once with power drop
2 3
Replies
43
Views
2K
Graculus
Graculus
G
P38 Keys not working
Replies
14
Views
2K
Grrrrrr
Grrrrrr
Rob4x40
L322 TD6 transmission adventures
Replies
13
Views
2K
badfluffy
badfluffy
S
P38A starting problem after overheat P38 4.6 2001 Vouge
2 3
Replies
44
Views
3K
Mark Piercy
Mark Piercy
S
starting problem after overheat P38 4.6 2001 Vouge
Replies
2
Views
272
Hippo
Hippo
Back
Top