2001 td5 loom

disco dickie · Jun 15, 2009

I fitted an injector harness a little time ago and was thinking about a new section of loom that goes from that to the ecu. Can you buy just that bit or is it going to be a bit more involved?

disco dickie · Jun 16, 2009

Headtester · Jun 16, 2009

Sorry no idea - but have a free bump anyway

martinhollings · Jun 16, 2009

you can buy an engine loom lookin therw the service history on my disco it was replaced when my injector loom was replaced

Stuarts the man · Jun 16, 2009

After doing the injector loom, you really need to do the other engine loom as it is still full of oil and makes its way still into your ecu

andyb66 · Jun 17, 2009

You don't need to change the engine loom, you can just clean it out.

disco dickie · Jun 17, 2009

I have tried to flush it with meths, its not too bad now. I was thinking it might have had something to do with my M and S lights flashing but going on what someone else has said on here it could be the XY switch on the gearbox. That sounds like a delight to do.

Td5disco · Mar 18, 2012

Hi i changed my loom today but the plug that plugs in under the harness broke (i broke it) it slips down and the engine cuts out i was thinking of getting a new plug and soldering it on existing wires is this my best bet? Or is the an easier soulotion im geussing id have to replace the whole engine loom to replace it propperly

ratty · Mar 18, 2012

Td5disco said:
Hi i changed my loom today but the plug that plugs in under the harness broke (i broke it) it slips down and the engine cuts out i was thinking of getting a new plug and soldering it on existing wires is this my best bet? Or is the an easier soulotion im geussing id have to replace the whole engine loom to replace it propperly

you may be able to cable tie it in position as a temporary solution. If there's nothing to cable tie it to, some rtv or similar sealant may secure it while you sort out a new plug.

The Mad Hat Man · Mar 18, 2012

Td5disco said:
Hi i changed my loom today but the plug that plugs in under the harness broke (i broke it) it slips down and the engine cuts out i was thinking of getting a new plug and soldering it on existing wires is this my best bet? Or is the an easier soulotion im geussing id have to replace the whole engine loom to replace it propperly

Do not cut & solder. Depending on plug, You can't anyway, You will need all the correct pins & crimp tool. It is an IP rated connector.

Send me a pic.

Oh - and change yo usercp so we know wherabouts you live.

2001 td5 loom

disco dickie

Active Member

disco dickie

Active Member

Headtester

Active Member

martinhollings

New Member

Stuarts the man

New Member

andyb66

Well-Known Member

disco dickie

Active Member

Td5disco

New Member

ratty

I'm not special I'm limited edition

The Mad Hat Man

Well-Known Member

Similar threads