Search results

hi ,i wish to replace the front subframe and what is the best way to do it,and how to do it,thanks in advance for your help

1996 4.6 gems ,i have a syncmate ,to resyinc becm and ecu,but does the door lock have to be working properly ,it only locks drivers door and boot,with key?thanks for any advice.

hi,anyone used marvel mystrey oil,?

hi wanted,lpg thor 4.6 1999 on wards ,with MOT,and gas serviced ,registered,thank you

hi,p38 gems 4.6 1996 wont start,i have petrol in rail under pressure,have spark,fuel not going through injectors, i have a syncmate and a nanocom, it says mobilised yes,new fuel cut off switch,new plugs ,new coil,new fuel pressure regulator,new ht leads,new filter,and petrol pump. nanocom says...

hi, i would like a known working ERR 6645 ecu for gems 4.6 1996 hse thankyou rick

hi any one know,where to get my ecu looked at replaced or repaired ERR 6645 thank you.i wont go on e-- y as the three purchased in the past were duds,you live and learn i supposed

query, please, if you take the heads off a 4.6 gems,will the timing be out when you put heads back on?i have turned crank over ,to look at pistons and fly wheel,thanks

hi,i need a 4.6 gems engine for my 1996 p38 in good condition,thanks

hi folks, any ideas to help please,i have no petrol to plugs,have fuel pressure to rail,have spark,have check light,which goes out when cranking,no faults on nanocom,also does the rev counter move or not when cranking,?it will try to fire with easy start,thank you for looking.

hi, please clarify,what might help,p38 1996 gems 4.6, key in position 2,check light on,position 3,engine cranks,check light stays on,sought of flashing when cranking,no start? it has p0335 code a circuit malfunction,has new ckps? is it still sync issue do you think,thanks for help.

merry christmas one and all.

hi,does anyone know the depth of the spacer,for this sensor,it is the one with out wire attached,thankyou

genuine range rover crankshaft position sensor ,new,£40 on ebay?rimmers £200?

happy new year every one

i changed radiator on my 1996 4.6 p38.tested old radiator by laying on the ground filling with water it took 41/2 pints, tested new one the same,6pints ,hope this might help somebody, dont know how long the old one was in their,