Search results

Morning everyone. I'm pondering my next project and was thinking maybe having a punt at a toylander type affair. Is there anywhere you can download the plans from that you good folks are aware of? I looked at the official stuff and it's a tad on the pricey side (yes I am a tight arse I know)...

Hey guys I know it has been a while since I was last around. Life seems to be throwing as much at me as it can and The 110 has developed an interesting issue I hope you can help me with. I put a discovery 200 tdi engine into the 110 and until a couple of weeks ago all was well. I have...

Right then I changed the turbo on the 200tdi and it still smokes like a pig. No oil in the water or vice versa so maybe not the head gasket (probably id though knowing my luck). Any other ideas of what it could be before I mothball the bloody thing?

I am a little stuck folks, so if I could pick your brains it would be appreciated. I have replaced the 2.5 n/a engine with a 200tdi engine. I want to use a 300tdi fuel filter and housing but I am buggered if I can figure out how to plumb it all together? The pipework from the 2.5 n/a still...

Ok then I have fitted a 200tdi into my old "D" reg 110. It's a Discovery 200tdi and I have the conversion bit from the manifold already. So what exhaust should I buy? Do I buy the full 110 200tdi one or put back on a 2.5 system with both needing a bit of modding to make them par up at the...

I am looking for a set of wheels and tyres to fit a Discovery 1 with a 2" lift in the Nottingham Derby area. Don't want to spend a fortune so what have you good folks got?

Afternoon folks. Would a transfer box from a 300tdi Discovery fit my 110 Defender LT77 gearbox without modification? I am looking to swap out the military 1:6 ratio that's fitted for a better cruising speed when touring :)

OK then I have fitted new discs and brake pads to the Disco 1 only to find that now the inner brake caliper pistons on the nearside have seized in place fully pushed back. What's the best way to free them up again? I am kind of stuck here with it so any suggestions appreciated.

Could you good folks tell me what size fuel pipe do you good folks use on your land rovers then? My 110 has got the 2.5 n/a and the pipes are shot so all need replacing from the tank to the injectors and I was wondering the best size to order.

The 110 has a 2.5 n/a fitted but the air filter housing is missing a couple of clips. I cannot find these clips on-line for love nor money so :- * Does anyone have these clips for sale * Does anyone have a filter housing for sale with the clips on * Can I just stick a different air filter...

Right then I expect that this has been asked and I may be searching for the answer incorrectly so if so I apologise in advance folks. "Blue" my "R" reg Discovery 300tdi does not seem to have any preheat at all going on. There is no light ever on the dashboard and it was pretty damned sluggish...

I have managed to scrape £800 together for a Disco I might even be able to beg a bit more off of the wife. I need one to get me through the Winter as I am putting the bike up for sale and taking it off of the road. No more defrosting my fingers either end of a commute or the worry of slipping...

OK then folks I need to replace the door pillars on both sides of my 110 but could you all give me some advice on the best way to do it please. Do I just remove as much of the old rotten ones before fitting the new or cut the whole lot out as you would do with any other welding leaving the hinge...

Does anyone have a diagram of a 2.5 na diesel injector pump please? Want to make sure I have put the springs back on in the right place because the bugger wont start now after changing the O ring on the throttle shaft.

It Has Arrived... The 110Posted by Nicky Smith Sun, October 18, 2015 15:46:47 The day did not start well. Last night when I went to bed at a far to unreasonable time for a weekend, 9:20pm, I was feeling pretty rough and it was not through anything fun that I had done like a quick drink at...

Welcome to the sale of Brian my off road ready 300tdi Discovery 1 on an L plate. Brian was completely standard when I bought him about six months ago but after a restoration I had just finished on a Series 3 I was a bit bored and decided I would get him off road ready so I could play with my...

Afternoon folks, A quick question that has probably been asked before but I cannot seem to find an answer! That probably says more about my searching the internet skills than anything else but hey ho. I need a Drop plate towbar for my Discovery 1 and have been offered one off of a...

Now I don't know if just one person owns this great forum or a collection of folk but could someone from either group please send me a PM :)

First things first I am only selling "Mator" my series 3 landy because we are buying a house and need the money for a deposit quite frankly after all the blood sweat tears and the hospital visit he caused me I don't want to see him go but they have been well worth it. This is a unique...

And So It Begins... The Discovery Project... Posted by min200 Sun, March 22, 2015 08:34:46 For those that have followed me before you know I have spent the best part of a year rebuilding an old Series 3 Military FFR Land Rover using what was my cigarette money and trying to show you could...