Recent content by mburton2
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
M
Or the feed to the cigar lighter....but as mentioned above, take a (Fused) feed from the battery to a suitable relay, & switch the relay from the "ignition-fed" source.
-
M
Well, just ordered a set of callipers/disks etc for the front, when I get round to fitting those (just so I know everything is shiney & new ;)), I will do a complete fluid change.
-
M
Well.....I kinda thought this...but surely, if I loosened off the bleed-nipple to release any pressure, the calliper would/should retract enough allow the hub to spin?
-
M
OK..Long story, but I'll try to keep it short..Im now stuck for Ideas
1) Horrid screech from RNS wheel, which is also too hot to touch....Quick investigaition shows a sticky caliper. Disassemble..grease/copperslip appropriate bit & Re-assemble.
2) Rear wheel still over heats...Splash the...
-
M
Subsequently found at Crays Hill, having been used as a Ram-raid vehicle.
Apparently:
"they" got disturbed & fled the scene...by the time the police had got there, the roof & rear doors had been nicked. :mad:
-
M
ratchet-strap a storage-box in?.
If you still have the "dickie-seats" in place you should be able to use the seat-belt straps as suitable anchor-points?
Sent from my GT-I9300 using Forum Fiend v1.0.1.
-
M
:( dont say that! ... mines been fixed for about a year now...I *DO* hope it lasts a LOT longer! !
Sent from my GT-I9300 using Forum Fiend v1.0.1.
-
M
Near the Back?....LHS (When looking from the top: Bonnet up?).....IF this is the case, there's a high chance its the Fuel Pressure Regulator. Cheap repair kits available....but its a bit of a nightmare getting to it...
EDIT
I used this guide when I did mine:
http://www.discovery2.co.uk/Fpr.html
-
-
M
No Pics of the (Free) Sat-Nag software that shows By-ways/lanes ?? ;)
-
M
How about a Poachers-trap type thing (Blank shot-gun shell, with a spring-loaded firing pin type cage araound it) in the cab?.....connected to the clutch pedal?. Would make a hell of a bang in the cab....
Just dont forget you fitted it!
EDIT
I see this approach has been covered earlier in...
-
M
The bay of e?..
search 18w led worklamp
-
M
I wave at all Disco's, Defenders/Series...& even Freelanders (Having had a couple of them myself)...
But there is a problem....I often get to drive different vehicles from work....& when I forget I'm not in one of my Disco's, I *DO* get odd looks from other Landy-drivers!.
-
M
Or indeed, a dieing starter motor would make the engine crank slowly, even with good batteries. I recently put a new starter-motor on & it now cranks faster than it ever has before, and starts REAL quick.
-
M
Havnt you got work to do?? ;)