Wires from Engine bay into car

Hello again everyone!
- has anyone found an easy way or location to put wires through from the engine bay into the vehicle. I am just in the process of fitting a little device for the light theiving scumbags!

What disco are you refering to? as they are not all the same.

You could just drill a hole in the bulkhead so it enters just behind the glove or fuse box.

I had an existing hole below where the throttal cable enters into the cabin which was blanked with a rubber grommet, the hole is big enough for a grommet and a power cable to feed an amplifer.

And don't foget that the bulkhead has holes both sides so the wiring can be fed on opposite side for LH drive motors. so easy to knock a blanking panel and fit a rubber grommet.

Its a 2003.. Im struggling to find one but think it must be my eyesight!

cruiser102 said:

Its a 2003.. Im struggling to find one but think it must be my eyesight!

Click to expand...

Get on you're hands and knees on the passenger side and peel back carpets etc where it disappears behind the glove box. Shine ya torch in there and you'll be able to see the cut outs for the LH drive motors Once ya spot one drill an hole and stick a rubber grommet in it

Ah.. Great stuff thanks very much! Found one! In the perfect place too where i needed it to come through.

Cheers chaps