wheres that f&é'"(g spider?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

ajr2010

New Member
Posts
5
Hi everyone

I have been looking through the threads for clues to if my 1997/98 Disco has got a spider and if so where is it? Want to fix the bypass connector to avoid trouble in the future.

Sorry to go over old ground but couldn't find an answer.

Would really appreciate the help cos I live in France and there is only one very greedy Landy garage in my region.

Cheers
 
I have read the 'definitive alarm spider post' already! I took my dash apart and there was no spider! I cant see it any where under the steering wheel or behind/underneath the dashboard.

Does it look different on a Discovery 300 TDI 2.5 Estate 1997/98? Or does it just not exist?

Thanks
 
heres where you should find the spider unit and what it takes to get to it. i took me about an hour and a half start to finnish :)
 

Attachments

  • 01 dash.jpg
    01 dash.jpg
    232 KB · Views: 364
  • 02 heater nobs removed.jpg
    02 heater nobs removed.jpg
    236.9 KB · Views: 223
  • 03 clock out.jpg
    03 clock out.jpg
    237.6 KB · Views: 208
  • 05 drink holder out.jpg
    05 drink holder out.jpg
    236.2 KB · Views: 199
  • 06 top screws.jpg
    06 top screws.jpg
    235.5 KB · Views: 202
  • 07 hidden screws.jpg
    07 hidden screws.jpg
    232.9 KB · Views: 245
  • 08 spider unit.jpg
    08 spider unit.jpg
    231.8 KB · Views: 370
  • 09 spider remove.jpg
    09 spider remove.jpg
    217.7 KB · Views: 574
  • 10 spider replaced.jpg
    10 spider replaced.jpg
    233.8 KB · Views: 251
  • 11 problem joint.jpg
    11 problem joint.jpg
    217.7 KB · Views: 241
Have a look at the back of the injection pump - see can you see the stop solenoid .
If you can see the stop solenoid you should have a spider ; if there is a lump of black plastic with a few wires going into it covering the stop solenoid you , don't think you have a spider.
Not very technical I know but when my sisters 98 Tdi had starting problems I found out that much . I had to take off the black plastic lump which apparently is part of the immob system and controls the feed to the stop solenoid .
Took me ages to get it removed - then wired stop sol direct and its fine since .
Hope this helps .
 
Back
Top