What have you done to your Landie today.

put the exahust on, took it off again ground of the offending clutch bracket, put it back on again,done all the hoses, finished the fuel side made a start on the electrics, made it waha click click click bloody flat battery.

Also ended up a differnt colour neve seen so much oil all over a motor.

such fun

forgot to add found a leak in the fookin rad

snap

probably the same fix to si

YESTERDAY DROPPED and replaced atf, refilled rad, swapped off spare, took out carpets to dry, found out sound insulation is a sponge, put new number plate on

Started It And Turned It Round Jetwashed It :d

Its Alive Its Alive

Sirus said:

Its Alive Its Alive

Click to expand...

Still got th zorst to finish, intercooler to pipe and the leaks to fix, but on the home straight

Ah renewed the radius arm bushes, lower link bushes, panhard rod bushes (still got me A frame bushes to do). Then ah renewed me engine mount bushes

varnished the wood for the rear storage area and marked out were the foley side lockers are going to go, then i checked on here and they look diffrent to how i have marked them out!!! will have another look tomorrow as i have got a headache from the varnishing.

ive stuck me bumper end bak on, it just fell orf..............good old landys....

Just recived my door frame repair kits now just waiting for the skins then i can start fixing them up

Tyr said:

Just recived my door frame repair kits now just waiting for the skins then i can start fixing them up

Click to expand...

where did you get em from and how much if you dont mind,mine are fooked

I just drilled and tapped my disco transfer box casting blanks to accept the 90's handbrake bracket ready for mr MOT man Friday. Also fitted front shock turret and a shiny new shock as it became loosley attached due to tin worm in the turret. Jai

nothing as i came home from work and fell asleep on the sofa, will have to fit the foley side lockers tomorrow.

thought about it, looked at the sheet metal and ignored it .

going to workshop tomoz nite to make up both remaining floor panels.

went to get the tyres fitted, discovered lockin wheel nuts and ordered the key from LR for £7.99


try again tomorrow

Tried tae investigate me serious vibrations after fittin' me rubber engine bushes yesterday... couldn't find anything obviousHad a mate there to help but still no joy! So he done me tappets for me while ah turned the crank from below

checked to see if difflock was functioning, it wasn't.
Fitted tow pack loom.
Cleared all my tools out, secured gas bottle for cooker, and packed it out with camping gear.

coz1 said:

where did you get em from and how much if you dont mind,mine are fooked

Click to expand...

Craddocks for the skins can give you the part numbers if you like but they dont have them in ali only steel now, which is better i think, no more bubbling and the fram repair kits from YRM metal solutions skins for all four came to bout 300 and the frame repair kits bout 16 pounds for a 1.5m lenth