ujs and front hubs

pauls440 · Sep 4, 2011

Hi all yet another question
I think i need new uj's and maybe all the bits on the front as I'm getting a vibration and a noise like a worn bearing ,
so I'm thinking start with the uj's and going from there.
i have a 2" lift and i think this was the start off the problem , iv ordered a new set off standard springs to replace,
and wares the best place to get them from

any help would be appreciated

The Mad Hat Man · Sep 4, 2011

yu wanna sell yo rear springs?

pauls440 · Sep 4, 2011

sorry but i think my brother wonts them

cuza68 · Sep 4, 2011

if you are having a noise from the front end and are thinking of changing the wheel bearing then you might aswell change the cv joint aswell. saves time

bigrichsri · Sep 5, 2011

pauls440 said:
Hi all yet another question
I think i need new uj's and maybe all the bits on the front as I'm getting a vibration and a noise like a worn bearing ,
so I'm thinking start with the uj's and going from there.
i have a 2" lift and i think this was the start off the problem , iv ordered a new set off standard springs to replace,
and wares the best place to get them from

any help would be appreciated

If you've got a noise that sounds like a worn bearing, I'd start by looking for a worn bearing

nrgserv · Sep 5, 2011

check fron prop uj's. then gearbox output flange to front prop.

pauls440 · Sep 5, 2011

ok is there any one near me that could have a lisson to the hoise to see what they think

Mr Noisy · Sep 5, 2011

front prop most likely

give it a good wiggle to see where the movement is, as it could also be transfer output bearing as stated above.

my advice is find the problem yourself and then you does become educated.

ujs and front hubs

pauls440

New Member

The Mad Hat Man

Well-Known Member

pauls440

New Member

cuza68

New Member

bigrichsri

Active Member

nrgserv

Well-Known Member

pauls440

New Member

Mr Noisy

Coming in your ears.

Similar threads