TD5 coolant system bleed screw replacement...

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

TaDa

Active Member
Posts
432
Location
Barnstaple or thereabouts
Hi!

I sheared off my bleeder screw head yesterday - it seems they're weak (and I'm strong :doh: - ooh I could crush a plastic screw!)

Anyway, microcat tells me that my car does not have one fitted (!!) - though it does show it having the whole section of hose it screws into.

Is the screw replaceable or do I need to buy a whole new section of hose?

Cheers
 
If you have the one that's moulded into the hose itself, then it is well worth upgrading to the later one with the screw moulded into the plastic bit.

I'm assuming that TD5's have a similar arrangement to the V8's.

It isn't sold as a separate part, but I have seen them on fleabay.

Peter
 
I bought the screw and installed it today.
I had to drill a slot in the thread of the old screw with a 1mm drill and undo it with a small screwdriver.
I'll try not to break that again!
 
Are you saying a stainless steel screw to replace the bleed screw?

Its probably safe enough - but I would be concerned about:

  1. The metal thread wearing away the hose's thread as you screw it in
  2. The metal expanding differently to the rubber and wearing the hose's thread

The more I think about it the more I think I'm overly concerned.
Firstly you're probably not goint to be removing/replacing the screw that often
and secondly I doubt the metal screw would expand that much

On the whole a good idea then :)

Would a soft rubber washer be an improvement?
 
Hi All

on my 04 disco 2 td5

Ive just had the 3rd screw break on me in as many months. replaced the hose as well last time. Is there a better fix for this yet rather than using these silly plastic screws. have seen the brass screws on ebay from oz but nothing in the uk. also seen mention of a t-piece modification but no details of supply source.

appreciate any advice
many thanks
 
Whats wrong with a 6mm flange head bolt ? Been working fine in my TD5 for ages - one less thing to go wrong.Same deal in the bottom of the fuel filter too.(They put a lot of diesel on the road when the stupid plastic drain screw or water sensor gets knocked off..)
 
Back
Top