Gord Wedman
Well-Known Member
- Posts
- 612
- Location
- Chilliwack, British Columbia
About 2 months ago a bought an 08 LR3 with 165k km to replace my 99 P38 for offroading. This car has the 4.4 V8.
For a while I had been smelling coolant in the engine compartment. Monitoring coolant levels they never went down, there were no drips, and a look inside revealed nothing obvious so I didn't immediately investigate further. Finally I took off the engine cover and discovered 2 spots that seemed to be weeping, one at the thermostat cover and the second at the left side horizontal pipe. Looked like a hairline crack in the thermostat cover while the O ring must have been leaking at the pipe. Bought a replacement from Rock Auto for $124CAD and $26CAD for FedEx shipping to my door. Arrived really fast, something like 3 days. Took my brother and I 2.5 hours to remove old assembly. Main issue is that you have to remove the throttle body to get at the 4 machine screws holding the rectangular section to the top of the engine. A 1/4 inch drive socket set is handy for the tight places. Took us 2 hours to put it all back together. All good now. Also replaced my Low Coolant sensor which was not working. This just snaps into the bottom of the overflow tank.
For a while I had been smelling coolant in the engine compartment. Monitoring coolant levels they never went down, there were no drips, and a look inside revealed nothing obvious so I didn't immediately investigate further. Finally I took off the engine cover and discovered 2 spots that seemed to be weeping, one at the thermostat cover and the second at the left side horizontal pipe. Looked like a hairline crack in the thermostat cover while the O ring must have been leaking at the pipe. Bought a replacement from Rock Auto for $124CAD and $26CAD for FedEx shipping to my door. Arrived really fast, something like 3 days. Took my brother and I 2.5 hours to remove old assembly. Main issue is that you have to remove the throttle body to get at the 4 machine screws holding the rectangular section to the top of the engine. A 1/4 inch drive socket set is handy for the tight places. Took us 2 hours to put it all back together. All good now. Also replaced my Low Coolant sensor which was not working. This just snaps into the bottom of the overflow tank.
