Daves disco
Member
- Posts
- 57
- Location
- Nottingham
My 2002 disco td5 has the solenoid s/c or o/c message on the Nanocom. I’m assuming that the solenoid is defective. Is the solenoid easy to access/change without taking the box off? Thanks.
Solenoid 2 s/c o/c
- Thread starter Daves disco
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
steve2286w
Well-Known Member
- Posts
- 4,577
- Location
- monkeyangerland
i would check the wiring first … short circuit or open circuit, maybe repeat this in the disco forum too more disco peeps will see it
sierrafery
Well-Known Member
- Posts
- 17,911
- Location
- Arad/Romania
Maybe if you tell which ECU is involved and the exact code you get otherwise it doesnt make much sense especially that you are in the engine section here
Daves disco
Member
- Posts
- 57
- Location
- Nottingham
P0758 solenoid valve 2 monitoring. As far as which ECU is concerned, no idea.
sierrafery
Well-Known Member
- Posts
- 17,911
- Location
- Arad/Romania
When you connect nanocom you have to select an ECU first then it shows codes for that one so you dont know which ECU you selected?.... anyway according to the code seems that it's about the autobox's shift solenoid MV2, you have to remove the valve block to replace that but in this case it can be the very common "P clip" issue when the gearbox harness gets hurt where it's clipped to the top of the box so that's what you have to check first
Daves disco
Member
- Posts
- 57
- Location
- Nottingham
Thanks. For further info, I checked the level of the ATF, going through the correct procedure, and I’ve put around a litre plus in. The M&S lights extinguished and cleared the code. 12 hours later, the M&S lights are back with the same fault code.
sierrafery
Well-Known Member
- Posts
- 17,911
- Location
- Arad/Romania
IMO the oil level has nothing to do with that code, it's the harness or the solenoid
Daves disco
Member
- Posts
- 57
- Location
- Nottingham
It’s probably coincidental.
