mono78v
New Member
- Posts
- 106
- Location
- nottingham
Hi, can anyone offer me any advice on this.
My brake pads on the front of my 03 plate TD4 were getting quite worn so I changed them my self about 3 weeks ago. i've done them before on other cars i've owned. All seemed to go smoothly apart from a little spilt brake fluid when i wound the piston in, until today.
Maybe its not a problem but i noticed after the car hadn't been driven for a day or two a bit of surface rust on the disks as they do, problem is now i've taken it out for 5 or 6 mile drive today the rust has worn off some of the disk but some still has surface rust on. This is the same on both front disks. this made me think there not wearing evenly? Is this anything to worry about or will the new pads just bed into the shape of the disks in a few more hundred miles??
Thanks, Chris.
My brake pads on the front of my 03 plate TD4 were getting quite worn so I changed them my self about 3 weeks ago. i've done them before on other cars i've owned. All seemed to go smoothly apart from a little spilt brake fluid when i wound the piston in, until today.
Maybe its not a problem but i noticed after the car hadn't been driven for a day or two a bit of surface rust on the disks as they do, problem is now i've taken it out for 5 or 6 mile drive today the rust has worn off some of the disk but some still has surface rust on. This is the same on both front disks. this made me think there not wearing evenly? Is this anything to worry about or will the new pads just bed into the shape of the disks in a few more hundred miles??
Thanks, Chris.