sas1810
New Member
- Posts
- 1,347
- Location
- back in Willenhall, West Midlands.
Good evening folks!
yep, its me again
I have finally got time to do a few jobs, preventive more than anything.
just got 4 new air bags, 4 new ride height sensors, 4 new ABS sensors, brake sphere and a few more small things.
now, bags, no problem after readings Keiths how to. sphere not a problem as long as it screws off. ABS sensors no problem, according to RAVE.
now the question.
after removing and fitting the new ride height sensors, do i really need the 100mm blocks that are mentioned? or can i just do it from the nanocom on flat ground and a tape measure?
i have searched but nothing definitive.
i know its been a while since appeared on here, but you notice i never left the best RR forum there is (creeping sod i hear you all say)
many thanks,
Dave
yep, its me again
I have finally got time to do a few jobs, preventive more than anything.
just got 4 new air bags, 4 new ride height sensors, 4 new ABS sensors, brake sphere and a few more small things.
now, bags, no problem after readings Keiths how to. sphere not a problem as long as it screws off. ABS sensors no problem, according to RAVE.
now the question.
after removing and fitting the new ride height sensors, do i really need the 100mm blocks that are mentioned? or can i just do it from the nanocom on flat ground and a tape measure?
i have searched but nothing definitive.
i know its been a while since appeared on here, but you notice i never left the best RR forum there is (creeping sod i hear you all say)
many thanks,
Dave