Air compressor running after engine is off

Evening all, after picking your brains again...

A couple of weeks ago my air compressor on my D2 for the rear bags kept running after the engine was off, this resulted in a knackered compressor. Today I have fitted a new one with new relay and fuse as this had also blown.

It ran fine for a while but then started to keep running after the engine was switched off again. The air bags are not dropping in height at all after I pulled the fuse to stop the compressor so that rules out a leak.
The fuse is starting to look a little worse for wear again so this might blow soon when I put it back in, keep in mind it's only a few hours old ...

Any suggestions as to what the cause or fix is?

Could the ride height sensors be playing havoc?

Any help appreciated

Defender or wife said:

The fuse is starting to look a little worse

Click to expand...

Hi, which fuse exactly?

Defender or wife said:

Could the ride height sensors be playing havoc?

Click to expand...

No, at this point the first suspect is the fusebox or in the worst case the SLABS ECU unless it's a wiring issue somewhere and that coud be a nightmare.

sierrafery said:

Hi, which fuse exactly?

No, at this point the first suspect is the fusebox or in the worst case the SLABS ECU unless it's a wiring issue somewhere and that coud be a nightmare.

Click to expand...

FL9 the fusible link is the one that had blown. I changed the relay and compressor yesterday, then the FL9 started to look rough again before I took it out to stop the compressor from running.

I have had a look quickly under the fuse box and everything seems ok underneath.

sierrafery said:

Hi, which fuse exactly?

No, at this point the first suspect is the fusebox or in the worst case the SLABS ECU unless it's a wiring issue somewhere and that coud be a nightmare.

Click to expand...

Can you do a straight swap for the SLABS ECU, plug and play as long as it's from a disco with air bags?