Dazza115
Member
- Posts
- 23
- Location
- Gloucestershire
Hi all, does anyone know the tightening torques for the rear tie bar
Inner nut and outer bolt (that goes to the bottom rear of each hub) then to the subframe above the exhaust.
This is for the bar that gives rear toe in/out when adjusted.
Also, do you put the inner at the lowest/highest/ mid position when installing as it has a about 7 mm of upward/downward travel on a slider.
Thanks in advance.
Inner nut and outer bolt (that goes to the bottom rear of each hub) then to the subframe above the exhaust.
This is for the bar that gives rear toe in/out when adjusted.
Also, do you put the inner at the lowest/highest/ mid position when installing as it has a about 7 mm of upward/downward travel on a slider.
Thanks in advance.
