ride height sensors, setting with hawkeye

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
If both sides are reading correctly ( at least in the ball park ) for the correct height measurements.
Have you tried to start the engine and then lower the jacks? in that order.

Cheers
 
They work on hall effect but there is a narrow margin they should work within that's why calibration is needed with blocks as the inputs to be 100% the same though small differencies are not visible.... but if your's is not on even level you certainly need calibration with tester to store the inputs for the good heights that's a fact, no battery disconnection or other ''trick" will help
 
If both sides are reading correctly ( at least in the ball park ) for the correct height measurements.
Have you tried to start the engine and then lower the jacks? in that order.

Cheers
i have got the same measurements as i have propped the pass side one un bolted, set all the car level and same height both sides from the ground, i cannot seem to fox the bloody thing, will have to find a nancom from somewhere, i thought this hawkeye would do it, i will have to ask Bigggeee!
 
Right! Today swapped passside one for the old one, car is sat balanced now, readings are within 2 counts, drove perfect, raised height on the button, got out opened rear door, jumped on rear step and can adjusted itself and is sat equal! dodgy new sensor maybe?
 
Back
Top