replacing front diff what's involved

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Drain diff oil
Wheels off
Calipers off
Drive flanges off
Hubs off
Stub axles off
Pull half-shafts
Prop off
Un-bolt diff
Pull out diff (fookin heavy)

Re-fitting is the reverse.
Might as well check CV joints, wheel bearings etc and replace swivel / hub seals while yer at it.
 
I would properly establish that the diff is the problem before doing the above. Start by checking the propshaft, drive flanges, etc.
 
I would properly establish that the diff is the problem before doing the above. Start by checking the propshaft, drive flanges, etc.
i aggree..
if it was the rear then thats a piece of ****s to change/look at

the front is more labour intensive.and would be a fooker if ya got it all apart and then found it wasnt the diff but just a uj:doh:
 
Sorry to dig up an old thread but looking to do this and wondered if anyone has any pictures that would help me out. Looking to do this the short way and unbolt the whole hub/cv assembly rather than stripping it piece by piece as suggested by Trewey above.
 
Back
Top