rear bumper removal on discovery 1

noiseboymart · Aug 8, 2009

Are there any tricks to getting the rear bumper off an old disco.Which set of bolts is it as they are all swines to get at.The pair that actually hold the bumper to the bracket or the ones that hold the bracket to the chassis.
Cheers

The Mad Hat Man · Aug 8, 2009

there are 4 bolts - the ones that go for-aft tend to shear the nuts with in the bumper - i had to cut my bumper up in situ and then just remove the bolts.

martinhollings · Aug 8, 2009

""""gas-axe""""

hughesy · Aug 8, 2009

Aye usually an absolute baaaaastard to remove without cutting it to bits.

briandisco · Aug 8, 2009

Worse than a front bumper?

Brian

hughesy · Aug 8, 2009

briandisco said:
Worse than a front bumper?

Brian

Front bumper's a piece of ****. You can get at the bolts easy enough and they usually undo. And if they don't they snap so no problem.

nicedayforit · Aug 8, 2009

noiseboymart said:
Are there any tricks to getting the rear bumper off an old disco.Which set of bolts is it as they are all swines to get at.The pair that actually hold the bumper to the bracket or the ones that hold the bracket to the chassis.
Cheers

Simple. If its a 300 Tdi.
Take the bumper lights out. Look in holes you will see 2 17mm (I think) bolt heads facing sideways. Remove bolts the bumper will come off.
Unlike the bolts under the bumper these 4 bolt heads are usually almost as new.
Other advantage, when you come to refit bumper it is fully aligned, no fiddling required.

rear bumper removal on discovery 1

noiseboymart

Active Member

The Mad Hat Man

Well-Known Member

martinhollings

New Member

hughesy

Well-Known Member

briandisco

New Member

hughesy

Well-Known Member

nicedayforit

New Member

Similar threads