Please Help - Girlie being taken for a ride?

toplizzy said:

Wadebridge.....on my tod and I am really at a loss as to how they have come to this amount......

Click to expand...

Sean said:

Si has got at least 1 disco box going, dont suppose he'd want much more than the price of a chippy tea for it - i've seen them go for as little as 20 quid for the entire GB and TB assembly - also seen then go for a couple of 100 as well

it really is a bolt off/on job - driver seat and panel off, middle panel off, drivers floor plate off, both props off (do yer UJ's while yer at it), transmision tunnel off, tranny brake drum and shoe mounting plate off, speedo cable off, replace the tranny box mounting bolts with 180mm M10 bolts with their heads cut off - this is so you can slide the tranny box out untill the output shaft is clear - length of wood across the seats with a short strop down and around the tranny box (if you put some twists in the strop using the plank this helps lower is by undoing the twists) - replace the output shaft seal - smear some goo on the mating faces of the new tranny box and hoist it back up onto the 5 studs that you've cut the heads off - slide it back on etc etc

you'll also have to swop the depender tranny brake cable adjuster frame onto the new disco tranny box as they are slightly different - i've done a good few of these but this one (on my own 110) is the first disco box i'd seen that didnt have all 4 M8 mounting holes pre drilled - just had to drill and tap 2 of the 4, simple task to do

might want to drain and refill the tranny box with ATF etc

highly recomended modification

Click to expand...

jai_landrover said:

EP90 surley.

Mine didnt have the m8 holes drilled so I had to drill and tap them afterwards too.

Easy task to do swapped mine out, and changed the Transfer box input seal and the output seals in about 4 hours. Jai

Click to expand...