p38 help
- Thread starter kev87
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
overheating?
ssmn1234
Active Member
- Posts
- 691
- Location
- Cairns, Australia.
- Check that your Aircon condensor fans are coming on, if car getting hot these should cut in regardless of aircon on or not.
- How is the viscous fan, can you hear it make alot of noise at startup when cold, should be making this exact same noise if getting hot.
- Check between the condensor coils and the radiator, there is a gap of about 1/2 inch and sometimes crud builds up in there causing poor airflow.
- The above are the easy ones you can check yourself, hope it' not a liner or head gasket to have these tested, unless you have correct tools you best take it to garage to diagnose, should'nt cost much.
- Posts
- 83,296
- Location
- Embasinga stocæ
i have the timing gear lock if yu need one.
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
befor you start pulling it apart take small pipe off top side of rad make sure you got water movment. how hard is your top rad pipe getting when it is running
ssmn1234
Active Member
- Posts
- 691
- Location
- Cairns, Australia.
You best be elimin8 all of the external possibilities first, then if that not fix it, get it tested at garage before you unnecessarly start pulling motor apart.
gavbriggs
Well-Known Member
- Posts
- 5,861
- Location
- Sheffield uk
firstly check the o rings on bottle cap, swap em round.
tighten cap up very hard,
if its still doing it and the little pipe runs freely get a hydrocarbon test done!
tighten cap up very hard,
if its still doing it and the little pipe runs freely get a hydrocarbon test done!
