I have just swapped an EDC 300TDI and Auto box from a 1997 R plate into 1998 S plate Disco 1. The donor vehicle was a manual but had the spider immobiliser on the injection pump, but the EDC pump just has the single wire to the fuel solenoid.
The problem I have is that I can't get the engine to start, it turns over fine and the EDC is getting power as the Check Engine light comes on the dash. I know I have diesel as far as the fuel fitter in the engine bay as I have cracked the outlet banjo bolt and I can see diesel coming out if I crank the engine.
I haven't been able to check there is 12volts to the fuel solenoid as I didn't have my multi meter with me today. I ave used the fuel engine loom and ECU from the donor vehicle.
Any suggestions of what to check next welcomed, or any other parts I need to swap over from the donor vehicle which I still have and is complete bar the engine and gearbox.
Thanks,
Jamie.
The problem I have is that I can't get the engine to start, it turns over fine and the EDC is getting power as the Check Engine light comes on the dash. I know I have diesel as far as the fuel fitter in the engine bay as I have cracked the outlet banjo bolt and I can see diesel coming out if I crank the engine.
I haven't been able to check there is 12volts to the fuel solenoid as I didn't have my multi meter with me today. I ave used the fuel engine loom and ECU from the donor vehicle.
Any suggestions of what to check next welcomed, or any other parts I need to swap over from the donor vehicle which I still have and is complete bar the engine and gearbox.
Thanks,
Jamie.