no fuel

Steve Elliott · May 28, 2010

hi I've got a 4.6P38, I ran out of fuel put a can in no joy since put two more in plenty spark but no petrol any ideas and help most gratefully received

Steve

Steve Elliott · May 28, 2010

I can suck fuel through from the tank to the inlet feeds, is it the fuel pump and why has it gone since i ran out of fuel?

smurphy · May 28, 2010

Steve Elliott said:
I can suck fuel through from the tank to the inlet feeds, is it the fuel pump and why has it gone since i ran out of fuel?

I ran out of fuel once, and found that the pump had gone too!

vougese39 · May 30, 2010

is it gas converted?
as the pump runns constantly even on gas and most people run them with next to nothing in the pump just over heats as it need the fuel to lubricate and cool it! not an easy job tank out as it does not have a hole under the seat

smurphy · May 30, 2010

vougese39 said:
is it gas converted?
as the pump runns constantly even on gas and most people run them with next to nothing in the pump just over heats as it need the fuel to lubricate and cool it! not an easy job tank out as it does not have a hole under the seat

That's what I did, but on a disco its a easy enough job. It took about 10 mins.

Steve Elliott · May 30, 2010

I wish ten minutes 4 out of five nuts undone one bitch to go then filler pipe then get the pump out, oh yes need a new exhaust now aswell any ideas for a good reasonably priced system guys

thanks

Steve

Steve Elliott · Jun 25, 2010

fixed the fuel pump easier to make an access panel cos if your fuel lines are anything like mine were it would be very very difficult to remove from pump while dangling the tank.
now to change the valve cover gaskets, is there a special tool cos i cant seem to find a socket to remove the retaining bolts

Steve Elliott · Jun 25, 2010

oh yes is there anything else i should know???

robp38 · Jun 25, 2010

Steve Elliott said:
fixed the fuel pump easier to make an access panel cos if your fuel lines are anything like mine were it would be very very difficult to remove from pump while dangling the tank.
now to change the valve cover gaskets, is there a special tool cos i cant seem to find a socket to remove the retaining bolts

you need a torx socket to undo them properly/easily. i managed to undo mine with an 8mm multidrive socket and a bit of pressure to stop it slipping round, then replaced them with allen bolts.

landrover 110 martin · Jun 29, 2010

i would go for making a hole in floor much better

no fuel

Steve Elliott

New Member

Steve Elliott

New Member

smurphy

Active Member

vougese39

Well-Known Member

smurphy

Active Member

Steve Elliott

New Member

Steve Elliott

New Member

Steve Elliott

New Member

robp38

Well-Known Member

landrover 110 martin

New Member

Similar threads