Steve Elliott
New Member
- Posts
- 19
hi I've got a 4.6P38, I ran out of fuel put a can in no joy since put two more in plenty spark but no petrol any ideas and help most gratefully received
Steve
Steve
no fuel
- Thread starter Steve Elliott
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Steve Elliott
New Member
- Posts
- 19
I can suck fuel through from the tank to the inlet feeds, is it the fuel pump and why has it gone since i ran out of fuel?
smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
I ran out of fuel once, and found that the pump had gone too!
smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
That's what I did, but on a disco its a easy enough job. It took about 10 mins.
Steve Elliott
New Member
- Posts
- 19
I wish ten minutes 4 out of five nuts undone one bitch to go then filler pipe then get the pump out, oh yes need a new exhaust now aswell any ideas for a good reasonably priced system guys
thanks
Steve
thanks
Steve
Steve Elliott
New Member
- Posts
- 19
fixed the fuel pump easier to make an access panel cos if your fuel lines are anything like mine were it would be very very difficult to remove from pump while dangling the tank.
now to change the valve cover gaskets, is there a special tool cos i cant seem to find a socket to remove the retaining bolts
now to change the valve cover gaskets, is there a special tool cos i cant seem to find a socket to remove the retaining bolts
Steve Elliott
New Member
- Posts
- 19
oh yes is there anything else i should know???
robp38
Well-Known Member
- Posts
- 2,503
- Location
- north devon
you need a torx socket to undo them properly/easily. i managed to undo mine with an 8mm multidrive socket and a bit of pressure to stop it slipping round, then replaced them with allen bolts.
landrover 110 martin
New Member
- Posts
- 83
- Location
- huddersfield
i would go for making a hole in floor much better
