Light bar

Ive just bought miself a light bar for mi disco.

Question is whats the best way to route the wires to it? do i need to drill the roof and if so what is the best way to seal it back up?

Cheers

i have heard that you can rung them down the n/s edge of the windscreen and silicone them in there to hold them in place and then the wires feed through the engine bay to the power source of your choice. i wired mine in different to that but i had an old roof mounted ariel that was'nt in use so i used that to feed mine through then siliconed around them from the inside just to make sure of it sealing.

Hi

I just installed a lighting bar to my disco, i ran the wires through a hole in the roof, down the side of the windscreen on the inside, the cover should come off. Then i ran it down through the dash to near where the fuse board is and then i ran it through the bulkhead to the battery. I Connected the earth wire to one of the bolts holding the lighting bar on and wired a switch into the dash. Drill a hole in the roof and get a grommet that the wire fits tightly in and force it into the hole, this creates a waterproof seal so no damp headlining!

Hope This Helps

Cheers for that, think thats what im gonna do now