LED Dash Light Conversion - Access

Al2O3 said:

It is tight. Might be tighter LHD as some cables may have to reach a tad further.

Click to expand...

Abner said:

Ok. All good as far as white bulb connector. Was able to thread the turquoise back and also able to find slack in speedometer cable helping access. However.. the black bulb socket wont seat all the way (see pic).. led head too far! Ha. Should be easy project gone astray.

**Can I ask what manufacturer you and/or Aura used? Another post when I had looked recommended eastern electronics but they stopped selling and referred me to this place.. the bulbs I maybe should have gotten are https://www.superbrightleds.com/mor...d-led-tower-miniature-wedge-retrofit-car/206/

Thanks again and apologize in advance for my idiocracy

Click to expand...

KISSMYAURA said:

Did this Blue LED dash a while ago, very happy with it, not everyones cup tea, but then again i don't make tea for others!
V bright light on left of second pic is alarm I fitted behind binnacle glass, camera caught it when it was flashing.
You need to use 360 degree 'cob' led's which I now have fitted else you get a spot projection on the heater controls as in the picture.
I used 501 push fit holders, they are collapsable so will fit a variety of holes, and come with plenty of cable £99p each.
See here for the LED headlight and full vehicle conversion.
https://www.landyzone.co.uk/land-rover/td5-90-project.301491/


View attachment 158702 View attachment 158703View attachment 158704
View attachment 158705

Click to expand...

mick the builder said:

Ooooooooh I like that.

Click to expand...

Al2O3 said:

I'm presuming at 2.26AM, you're judgement is impaired.

Click to expand...

mick the builder said:

You have an unpure mind. I've just finished work.

Click to expand...