gearbox low vibration between 30 and 50 mph
- Thread starter rrgonzo3
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 12,659
- Location
- Sud ouest France !
Isn't the warranty à certain mileage or time? 5000mls isn't a lot at all??
- Posts
- 33,893
- Location
- North Shropshire
I had some work done on my car a few years ago, the warranty was 10000 miles or 12 months
- Posts
- 33,893
- Location
- North Shropshire
Are you sure it's the box and not something else that is 'traveling'? Wheel or diff bearings? Prop shaft UV?
- Posts
- 12,659
- Location
- Sud ouest France !
You may need to contact citizens advise as with the covid your car may not have been driven at all. I don't know if this affect your guarantee.
5000 miles on a substantial repair job is a little too short in my eyes.
5000 miles on a substantial repair job is a little too short in my eyes.
- Posts
- 12,659
- Location
- Sud ouest France !
Good point, have a second opinion on the noise and vibration, it could save a lot of disappointment if it's something less serious.
gold rover
Well-Known Member
- Posts
- 10,290
- Location
- dùthaich Dhè fèin
Have you checked your injectors?
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Did they change the oil cooler and pipes? They can hold contaminated oil and swarf that will bugger your new box and t/c.
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
Front Diff.
check the oil.
check the oil.
Hi yes had new oil cooler and pipes fitted when new gearbox fitted
on 12000 mile gearbox service had the whole system flushed and new oil and filter fitted
I have had wheel bearings and drive shafts checked but still the vibration is there
on a previous thread someone mentioned that an oil seal in the gearbox can cause this any one have any thoughts
on 12000 mile gearbox service had the whole system flushed and new oil and filter fitted
I have had wheel bearings and drive shafts checked but still the vibration is there
on a previous thread someone mentioned that an oil seal in the gearbox can cause this any one have any thoughts
- Posts
- 12,659
- Location
- Sud ouest France !
Having the wheels and power train turning while on a ramp could help the problem. Maybe a bent wheel or prop just slightly out of true?
