I have recently had an engine swap from a 16p to a 10p , but its not running correctly. As far as I'am aware the ECU hasn't been swapped.
I have had it on a Nanocom and it read the following faults:
[1.5] drive demand problem
[2.8] Ambient pressure circuit... this was reading 2.79
[1.2] Turbo waste gate
Can my ECU be reprogrammed to work with a 10p engine?
Can this be done without the vehicle being present? (just sending the ECU)
If anyone could give me some advice I would be most grateful.
I have had it on a Nanocom and it read the following faults:
[1.5] drive demand problem
[2.8] Ambient pressure circuit... this was reading 2.79
[1.2] Turbo waste gate
Can my ECU be reprogrammed to work with a 10p engine?
Can this be done without the vehicle being present? (just sending the ECU)
If anyone could give me some advice I would be most grateful.