Cutting out!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

kris6144

New Member
Hi guys still a bit new on here and i have had a look through the last few threads talking about this problem. so here we go!

i recently replaced my fuel pump then the new one broke!! so replaced with a more expensive one :(:( . then driving along the engine started to shudder revs dropped and the engine cut out. this happened on a straight road and again on a steep hill. after waiting and trying to start she went after about 10 mins. then nothing happened until the weekend when it happened again and then again to night! My cousin has suggested the earthing straps clean them and make sure they are not full of rust etc clean them if needs be. Oh and i have changed the waste gate valve last week as i thought that might have been that.. can anyone give me more pointers?? :confused::confused::confused::confused::confused:

thanks Kris
 
you have to rule out some things:
1. replace the main relay(R9) or swap with R8(heated screen) and the fuel pump relay(R1) with R3(headlamp wash) ...both in engine bay fusebox

2. check the plug/wiring of the inertia switch

3. addapt a fitting to a pressure gauge and screw it instead of the temp sensor in the FPR...see if you get constant 4 bar there

i presume you have a new quality fuel filter there...is the pump noisy when you turn ignition on pos II ?
 
Last edited:
Yes injector seals and washers and get a test book put on if it comes up top side switch ecu fault
 
thanks guys.. No black sludge and by the sounds of it glad i did not.. i will have a look at all of those tips when the weather breaks lol. fuel filter is britpart and changed same time as the pump. and works at Pos II nice werring noise!!
 
Back
Top