Auto box gear indication light
- Thread starter biggen
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discool
Well-Known Member
- Posts
- 13,628
The plastic frame surounding the selector can slid slid forward (may be backwards I forget now) to unclipped and lifted up and then you can see the two bulb holders (one each side) you can just about get to them to twist and release, I used pointed pliers as it was so tight for my fingers and there was also some carpet ends in the way 
The Haynes book shows how to replace all the bulbs in a disco.
The Haynes book shows how to replace all the bulbs in a disco.
Big Stu 12
Well-Known Member
- Posts
- 1,940
- Location
- Suffolk & Essex
I had the same problem
At the rear of the gear leaver you can leaver up the outside trim, once this if off you will see two laps one each side these were gone on mine, also there is a fuse that is in the fuse box under the flap on the driverside, think its fuse number 14, its the one that controls the lighing for the controls, dash, form memeory think its a red one..
Hope this helps.
At the rear of the gear leaver you can leaver up the outside trim, once this if off you will see two laps one each side these were gone on mine, also there is a fuse that is in the fuse box under the flap on the driverside, think its fuse number 14, its the one that controls the lighing for the controls, dash, form memeory think its a red one..
Hope this helps.
