ABS Sensor

Been having a bit of a nightmare with the 3 Amigos for a couple of weeks now.
I have had my fr n/s ABS Sensor replaced and all is well for a couple of days and then the ABS/Hill descent and TC Lights illuminate again.
It has been back into the garage but it has just gone again.(4 days this time )
Is it possible that the new sensor was faulty or am I missing something?
The mechanic told me that the electrical plug on the replacement was different.
It is a Y Plate TD5.
Any constructive advice is greatly appreciated.

To be able to give useful advice, you really need to get a fault code reader on it e.g. nanocom/hawkeye and report back what they say.

Without that info, you're really just grasping at straws.

David

1. it's only one kind of plug on D2 sensors
2. if it was a fault logged on that sensor and a new sensor didnt cure it u may have to replace the whole hub
3. read the fault codes again before u replace other parts... untill then u can drive it without fear

sensors can be tricky to fit properly ,remove new sensor clean hole out and fit without o ring and try it ,as above could be worn wheel bearing ,diagnostic kit wont know if poor sensor or wheel bearing or fitted not in enough

Thanks for the replies guys.
I will get the codes as suggested.
Lex