David Leech
Well-Known Member
- Posts
- 302
- Location
- Galway, Ireland
2001 Defender TD5
- Thread starter David Leech
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sierrafery
Well-Known Member
- Posts
- 17,910
- Location
- Arad/Romania
try ti figure it out from here https://www.brit-car.co.uk/product.php/83453/1217/sump_plug_washer_td5_defender___discovery_2
David Leech
Well-Known Member
- Posts
- 302
- Location
- Galway, Ireland
Yeh, I'd seen that. I might just pull the plug!.....
Discodevon
Well-Known Member
- Posts
- 1,454
You can turn it round the other way and use again if it hasn’t been already
- Posts
- 2,145
- Location
- East of England, UK
I buy them in packs of 10 they are very cheap. But if you do need to reuse it it’s best to anneal it first (heat it right up and let it cool naturally )
Also use a different motor factor!
Also use a different motor factor!
- Posts
- 6,660
- Location
- uk
I was taught to heat copper until it was cherry red and then plunge into cold water. Still works for me.
sierrafery
Well-Known Member
- Posts
- 17,910
- Location
- Arad/Romania
Not good IMO... afaik it's better to let it cool by itself... that cold water thing works for iron or steel, though i'm not a metalurgist
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
You might want to double check that SF..... on the ferrous materials.
Copper , on a washer, I would cold water cool, saves burning my fingers. But in reality probably would not make a big difference.
Cheers
